Cisco 352-001 Online Practice Questions and Exam Preparation

Cisco 352-001 Online Questions & Answers

• Question 701:

  What should be taken into consideration when designing IPsec networks using Authentication Header (AH)?

  A. NAT
  B. transform set
  C. crypto maps
  D. ISAKMP
  A. NAT

• Question 702:

  You have been asked to establish a design that will allow your company to migrate from a WAN service to a Layer 3 VPN service. In your design, you are keeping some WAN links between critical sites as a backup for this service. You plan to use OSPF as your IGP and BGP for the PE- CE protocol. When the Layer 3 VPN service is available, how will you prevent transit traffic over the backup links?

  A. Redistribute routes at the CE as external type 1.
  B. Redistribute routes at the CE as external type 2.
  C. Use conditional advertisement only when the Layer 3 service is down.
  D. Manually turn off the backdoor link when the Layer 3 service is up.
  D. Manually turn off the backdoor link when the Layer 3 service is up.

• Question 703:

  Why is a redundant PIM stub router topology a bad network design decision?

  A. Multicast convergence takes long
  B. Multicast traffic duplication will occur
  C. It interferes with IGMP snooping
  D. It interfaces with PIM snooping
  B. Multicast traffic duplication will occur

• Question 704:

  DRAG DROP

  An enterprise customer has a national WAN network based on DMVPN over the Internet, with sites located throughout the country. The customer has recently deployed VoIP throughout the entire network , and users report that it takes up to 2 seconds to establish a telephone call to an IP telephone at another office network. Drag and drop the root cause and the corresponding design solution from the left onto the correct targets on the right Not all options are used

  Select and Place:

  

  

• Question 705:

  Which option describes the fundamental design differences between an IP-based network design and a SAN-based?

  A. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic
  B. An IP-based design has redundancy from the host and high amounts of east-west traffic, whereas a SAN-based design uses redundancy in the fabric and very little east-west traffic
  C. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses zoning based redundancy which uses separate fabrics and has very little east-west traffic
  D. An IP-based design has redundant connectivity in the fabric and very little east-west traffic, whereas a SAN-based design uses redundancy in the host, which uses separate fabrics and has high amounts of east-west traffic
  A. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic