Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 411:

  What are the mandatory, well-known BGP attributes?

  A. origin, AS-path, next-hop
  B. AS-path, origin, MED
  C. AS-path, origin, weight
  D. AS-path, weight, MED
  A. origin, AS-path, next-hop

• Question 412:

  Why does RSTP have a better convergence time than 802.1D?

  A. it is newer
  B. it has smaller timers
  C. it has less overhead
  D. it is not timer-based
  D. it is not timer-based

• Question 413:

  Drag the statements on the left to the correct OSPF network type on the right.

  Select and Place:

  

  

• Question 414:

  When using IP SLA FTP operation, which two FTP modes are supported? (Choose two.)

  A. Only the FTP PUT operation type is supported.
  B. Active mode is supported.
  C. Passive FTP transfer modes are supported.
  D. FTP URL specified for the FTP GET operation is not supported.
  B. Active mode is supported.
  C. Passive FTP transfer modes are supported.

• Question 415:

  Which value should be used in a router configuration register in order to ignore the content of the NVRAM?

  A. 0x2102
  B. 0x2124
  C. 0x2142
  D. 0x2101
  C. 0x2142

• Question 416:

  Drag the DSCP values on the left to the correct classes on the right. Not all DSCP values will be used.

  Select and Place:

  

  

• Question 417:

  You are the network administrator of a medium-sized company, and users are complaining that they cannot send emails to some organizations. During your troubleshooting, you notice that your DNS MX record is blacklisted by several public blacklist filters. After clearing these listings for your IP address, and assuming that your email server has the right virus protection in place, what are two possible solutions to prevent this from happening in the future? (Choose two.)

  A. Change your Internet provider.
  B. Change your public IP address.
  C. Allow the email server to send traffic only to TCP port 25.
  D. Put your email server in a DMZ.
  E. Use a separate public IP address for your email server only.
  C. Allow the email server to send traffic only to TCP port 25.
  E. Use a separate public IP address for your email server only.

• Question 418:

  Refer to the exhibit. In this network, each router has a router ID as shown next to the router. While working on a software upgrade on R1 and R2, the network administrator notices that when the upgrade is finished, R4 is the designated router on the link. Is OSPF working correctly on this link, and why or why not?

  

  A. Yes, OSPF will never allow an existing DR to be replaced when a new router is connected to a broadcast network. In this case, the administrator has recently reloaded R1 and R2, so it would be expected that either R3 or R4 would be the DR on the link.
  B. No, OSPF should always elect the router with the highest router ID as the designated router on the link. The administrator should call for technical support.
  C. Yes, OSPF is operating correctly, because the router with the lowest router ID should always be elected designated router on a broadcast link.
  D. There is not enough information provided in the question to answer accurately.
  A. Yes, OSPF will never allow an existing DR to be replaced when a new router is connected to a broadcast network. In this case, the administrator has recently reloaded R1 and R2, so it would be expected that either R3 or R4 would be the DR on the link.

• Question 419:

  Refer to the exhibit. Which path is selected as best path?

  

  A. path 1, because it is learned from IGP
  B. path 1, because the metric is the lowest
  C. path 2, because it is external
  D. path 2, because it has the higher router ID
  B. path 1, because the metric is the lowest

• Question 420:

  Which command can be used to filter a RIPv6 route from getting installed in the routing table?

  A. ipv6 router rip ccie distribute-list..
  B. ipv6 router rip ccie offset-list..
  C. interface e0/0 ipv6 rip ccie distribute-list..
  D. interface e0/0 ipv6 rip ccie advertise..
  A. ipv6 router rip ccie distribute-list..