Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 371:

  Which three options are considered in the spanning-tree decision process? (Choose three.)

  A. lowest root bridge ID
  B. lowest path cost to root bridge
  C. lowest sender bridge ID
  D. highest port ID
  E. highest root bridge ID
  F. highest path cost to root bridge
  A. lowest root bridge ID
  B. lowest path cost to root bridge
  C. lowest sender bridge ID

• Question 372:

  Based on the exhibit presented. R2 does not have any 10.100.x.x routes in either its routing table or its BGP table. What will you do at R5 to solve this problem?

  

  A. Disable BGP synchronization.
  B. Set the BGP next-hop-self command for neighbor R2.
  C. Configure a static route for 10.100.0.0/16 to null0.
  D. Add a BGP network statement to encompass the serial link.
  C. Configure a static route for 10.100.0.0/16 to null0.

• Question 373:

  Refer to the exhibit.

  

  

  Clients in VLAN 10 complain that they cannot access network resources outside VLAN 10, and the internet. When you try to ping the default gateway from one of the affected clients, you get ping timeouts. What is the cause of this issue?

  A. VLAN 10 is only enabled on trunk interfaces.
  B. VLAN 10 is not created in the switch database.
  C. STP is not running on the switch.
  D. IP routing is disabled on the switch.
  E. The switch CAM table is corrupted.
  D. IP routing is disabled on the switch.

• Question 374:

  What protocol provides a mechanism to tranparently intercepts and redirects CIFS traffic from a client to a local Cisco Wida Area Application engine?

  A. File Transport Protocol (FTP)
  B. Hot Standby Routing Protocol (HSRP)
  C. Virtual Router Redundancy Protocol (VRRP)
  D. Web Cache Communication Protocol (WCCP)
  D. Web Cache Communication Protocol (WCCP)

• Question 375:

  Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link?

  A. anycast address
  B. site-local multicast
  C. global address ofthe link
  D. unique local address
  E. link-local address
  E. link-local address

• Question 376:

  Refer to the exhibit. AS65000 has core network P1-P6. The eBGP peers to another AS are through ASBR1-2 and ASBR3-4. All business and residential customer POPs currently are connected to the P1-P2 core. Which pair of routers is the best positioned to become a BGP route reflector?

  

  A. P1 and P2, as they have the same view of the exit point from the AS
  B. ASBR1 and ASBR2, as they have eBGP peers to another AS
  C. ASBR3 and ASBR4, as they have more eBGP peers
  D. a new pair of routers (RR1 and RR2) that are dedicated as a BGP route reflector that is connected to P1 and P3
  A. P1 and P2, as they have the same view of the exit point from the AS

• Question 377:

  Which standard supports multiple instances of spanning tree?

  A. 802.1 D
  B. 802.1s
  C. 802.1w
  D. 802.1 z
  B. 802.1s

• Question 378:

  Refer to the exhibit. Considering the following policer, which statement is valid?

  

  A. The Tc interval equals 125 ms
  B. Traffic exceeding 8 kb/s is systematically dropped
  C. The policer allows an excess burst of 1 kb
  D. The policer allows traffic to peak to 16 kb/s for the duration of a Tc interval if no traffic passed over the previous interval
  E. Traffic exceeding 8 kb/s is never dropped
  D. The policer allows traffic to peak to 16 kb/s for the duration of a Tc interval if no traffic passed over the previous interval

• Question 379:

  Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B.

  What would be two suggestions to load- balance the traffic across both WAN links? (Choose two.)

  

  A. Make HSRP track interfaces between the edge and core routers.
  B. Replace HSRP with GLBP.
  C. Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.
  D. Make R3 and R8 have lower HSRP priority than R1 and R7.
  E. Replace HSRP with VRRP.
  B. Replace HSRP with GLBP.
  C. Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.

• Question 380:

  Which of these statements about PIM join messages in classic PIM-SM is correct?

  A. PIM join messages are sent every 60 seconds to refresh the upstream router's mroute state for the multicast tree.
  B. Routers send a PIM join acknowledgement in response to each PIM join message received from a downstream router.
  C. PIM join messages are only sent when the multicast distribution tree is first being established.
  D. PIM join messages are sent every three minutes to refresh the upstream router's mroute state for the multicast tree.
  A. PIM join messages are sent every 60 seconds to refresh the upstream router's mroute state for the multicast tree.