Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 391:

  Which feature would prevent guest users from gaining network access by unplugging an IP phone and connecting a laptop computer?

  A. IPSec VPN
  B. SSL VPN
  C. port security
  D. port security with statically configured MAC addresses
  E. private VLANs
  D. port security with statically configured MAC addresses

• Question 392:

  By default, which bits are copied to the EXP bits in an MPLS label?

  A. DSCP
  B. ToS
  C. IP precedence
  D. CoS
  C. IP precedence

• Question 393:

  Refer to the exhibit. Which statement is correct?

  

  A. One of the IPv6 addresses is already used on another device on the same segment.
  B. Multiple addresses on the same subnet and on the same interface are not permitted for IPv6.
  C. The MTU is too small for IPv6.
  D. Multiple addresses on the same interface are not permitted for IPv6.
  A. One of the IPv6 addresses is already used on another device on the same segment.

• Question 394:

  What is the Cisco IOS command to turn on explicit null forwarding by LDP?

  A. ldp explicit-null
  B. mpls forwarding explicit-null
  C. mpls ldp advertise-labels explicit null
  D. mpls ldp explicit-null
  D. mpls ldp explicit-null

• Question 395:

  In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops can cause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limit excessive traffic during spanning-tree loop conditions? (Choose two.)

  A. loop guard
  B. storm control
  C. storm suppression
  D. broadcast suppression
  E. BPDU guard
  B. storm control
  D. broadcast suppression

• Question 396:

  Which parameter is used by a spanning-tree node as a tie-breaker if multiple upstream switches have an equal cost to the root bridge?

  A. lowest root bridge ID
  B. lowest root path cost
  C. lowest sender bridge ID
  D. lowest sender port ID
  C. lowest sender bridge ID

• Question 397:

  Refer to the exhibit. A small enterprise connects its office to two ISPs, using separate T1 links. A static route is used for the default route, pointing to both interfaces with a different administrative distance, so that one of the default routes is preferred. Recently the primary link has been upgraded to a new 10 Mb/s Ethernet link. After a few weeks, they experienced a failure. The link did not pass traffic, but the primary static route remained active. They lost their Internet connectivity, even though the backup link was operating.

  Which two possible solutions can be implemented to avoid this situation in the future? (Choose two.)

  

  A. Implement HSRP link tracking on the branch router R1.
  B. Use a track object with an IP SLA probe for the static route on R1.
  C. Track the link state of the Ethernet link using a track object on R1.
  D. Use a routing protocol between R1 and the upstream ISP.
  B. Use a track object with an IP SLA probe for the static route on R1.
  D. Use a routing protocol between R1 and the upstream ISP.

• Question 398:

  Refer to the exhibit.

  

  By default, why will BGP choose a locally originated route over any iBGP or eBGP learned route?

  A. The IGP metric to the next hop is always shorter.
  B. Locally originated routes have a better AD than eBGP or iBGP routes.
  C. All locally originated routes have a better origin code.
  D. Locally originated routes have a higher metric.
  E. Locally originated routes have a weight of 32,768.
  E. Locally originated routes have a weight of 32,768.

• Question 399:

  By default, EIGRP will use which percentage of bandwidth on an interface?

  A. 10%
  B. 25%
  C. 50%
  D. 75%
  E. 80%
  F. 100%
  C. 50%

• Question 400:

  When troubleshooting duplex mismatches, which two are errors that are seen on the half duplex end? (Choose two.)

  A. excessive collisions
  B. FCS errors
  C. runts
  D. late collisions
  A. excessive collisions
  D. late collisions