Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 331:

  While troubleshooting an OSPFv3 neighborship between two routers on a Frame Relay network, you notice that there is a mapping issue. Which mapping needs to be established for OSPFv3 to establish a neighborship on Frame Relay?

  A. The all routers multicast address needs to be mapped to the correct DLCI.
  B. The solicited node multicast address needs to be mapped to the correct DLCI.
  C. The neighbor's link-local address needs to be mapped to the correct DLCI.
  D. The all routers broadcast address needs to be mapped to the correct DLCI.
  C. The neighbor's link-local address needs to be mapped to the correct DLCI.

• Question 332:

  Which statement is true in regard to loop guard?

  A. Loop guard provides protection against miswiring.
  B. Loop guard works on a per-VLAN basis.
  C. Loop guard cannot be enabled on point-to-point links.
  D. Loop guard does not support autorecovery.
  B. Loop guard works on a per-VLAN basis.

• Question 333:

  Which value is used in the PIM TYPE field to indicate a Join/Prune message?

  B. 1
  C. 2
  D. 3
  D. 3

• Question 334:

  Prior to 802.1w, Cisco implemented a number of proprietary enhancements to 802.1D to improve convergence in a Layer 2 network. Which statement is correct?

  A. Only UplinkFast and BackboneFast are specified in 802.1w; PortFast must be manually configured.
  B. Only PortFast is specified in 802.1w; UplinkFast and BackboneFast must be manually configured.
  C. None of the proprietary Cisco enhancements are specified in 802.1w.
  D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.
  D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.

• Question 335:

  You are a network engineer for a company, study the exhibit carefully. The company's network is running EIGRP and you want to change the path R5 uses to reach 172.30.1.0/24 to R4. How could you achieve this goal?

  

  A. Change the bandwidth on the link between R2 and R5 to 70, and change the bandwidth on the link between R3 and R5 to 70.
  B. Change the bandwidth on the link between R4 and R5 to 110.
  C. Change the bandwidth on the link between R3 and R5 to 70.
  D. Do nothing, the best path to 172.30.1.0/24 from R5 is already through R4.
  A. Change the bandwidth on the link between R2 and R5 to 70, and change the bandwidth on the link between R3 and R5 to 70.

• Question 336:

  All of these are fundamental building blocks of differentiated services Traffic Conditioner Block except which one?

  A. dropper
  B. classifier
  C. marker
  D. querier
  E. meter
  F. shaper
  D. querier

• Question 337:

  How can excess packets be remarked?

  A. shaping
  B. policing
  C. priority
  D. all of the above
  B. policing

• Question 338:

  Which statement is true about TCN propagation?

  A. The originator of the TCN immediately floods this information through the network.
  B. The TCN propagation is a two step process.
  C. A TCN is generated and sent to the root bridge.
  D. The root bridge must flood this information throughout the network.
  A. The originator of the TCN immediately floods this information through the network.

• Question 339:

  Refer to the exhibit. When would the EEM applet be triggered?

  

  A. every time that the input errors counter is higher than 100
  B. every time that the input errors counter is slower than 10 errors per 10 seconds
  C. every time that the input errors counter is lower than 100
  D. every time that the input errors counter is faster than 100 errors per 10 seconds
  A. every time that the input errors counter is higher than 100

• Question 340:

  Having multiple unknown unicast frames in a switch would most likely deplete which of these resources?

  A. available MAC addresses in the system
  B. available memory for frame buffering
  C. available bandwidth
  D. electrical power
  E. TCAM entries
  C. available bandwidth