Cisco 350-001 Online Practice Questions and Exam Preparation

Cisco 350-001 Online Questions & Answers

• Question 161:

  If a certificate authority trustpoint is not configured when enabling HTTPS and the remote HTTPS server requires client authentication, connections to the secure HTTP client will fail. Which command must be enabled for correct operation?

  A. ip http client secure-ciphersuite 3des-ede-cbc-sha
  B. ip https max-connections 10
  C. ip http timeout-policy idle 30 life_120 requests 100
  D. ip http client secure-trustpoint trustpoint-name
  D. ip http client secure-trustpoint trustpoint-name

• Question 162:

  You are the network administrator of an enterprise with a main site and multiple remote sites. Your network carries both VOIP and data traffic. You agree with your service provider to classify VOIP and data traffic according to the different service RFCs.

  How can your data and VOIP traffic be marked?

  A. data marked with DSCP AF21, VOIP marked with DSCP EF
  B. data marked with DSCP AF51, VOIP marked with DSCP EF
  C. data marked with the DE-bit. VOIP marked with the CLP-bit
  D. data marked with DSCP EF, VOIP marked with DSCP AF31
  E. data marked with IP precedence 5, VOIP marked with DSCP EF
  A. data marked with DSCP AF21, VOIP marked with DSCP EF

• Question 163:

  Refer to the exhibit.

  

  A network engineer enables a new port channel between two switches. Both switches are configured for spanning-tree MST.

  What is causing the dispute message to appear on one of the switches?

  A. The switch received an IEEE 802.1D BPDU on that port.
  B. The BPDU that is received from the peer is inferior, with the designated role and state as learning or forwarding.
  C. The peer switch has been configured with a different VLAN instance mapping.
  D. The switch has received a malformed BPDU.
  B. The BPDU that is received from the peer is inferior, with the designated role and state as learning or forwarding.

• Question 164:

  What does a unicast prefix-based IPv6 multicast address start with?

  A. FF80
  B. FF3
  C. FF
  D. FF7
  B. FF3

• Question 165:

  Refer to the exhibit.

  

  The multicast sender and both multicast receivers are in the same VLAN. Multicast receiver 1 can receive the multicast stream from the multicast sender, but multicast receiver 2 cannot receive this stream. While troubleshooting IGMP, it is noticed that the IGMP report from receiver 2 is received by switch 2 but not by switch 1.

  Which action will solve this issue?

  A. Enable PIM on the SVI of the VLAN on switch DSW1 or switch DSW2.
  B. Add a straight connection between switch SW1 and switch SW2.
  C. Enable IGMPv3 membership reports on multicast receiver 2.
  D. Configure a rendezvous point on distribution switch DSW1 and distribution switch DSW2.
  A. Enable PIM on the SVI of the VLAN on switch DSW1 or switch DSW2.

• Question 166:

  Refer to the exhibit.

  

  

  Which two statements are correct? (Choose two.)

  A. The hexadecimal value of the number of packets that hit the access list is 0x723E6E12.
  B. The access list has logging enabled.
  C. The packet was discarded.
  D. The command ip access-list logging hash-generation is enabled.
  E. The Telnet connection is successfully set up.
  B. The access list has logging enabled.
  D. The command ip access-list logging hash-generation is enabled.

• Question 167:

  Refer to the exhibit. Routers A and B are directly connected. Given the configuration, how many EIGRP routes will router B see in its routing table?

  

  B. 1
  C. 2
  D. 3
  E. 4
  A

• Question 168:

  Which two of these parameters are used to determine a forwarding equivalence class? (Choose two.)

  A. IP prefix
  B. Layer 2 circuit
  C. RSVP request from CE for bandwidth reservation
  D. BGP MED value
  A. IP prefix
  B. Layer 2 circuit

• Question 169:

  Which two are natively included by the IEEE 802.1w standard? (Choose two.)

  A. instances can control a selection of VLANs
  B. load balancing
  C. fast transition to forwarding state
  D. backbone, uplink, and portfast (or equivalent)
  E. root, loop, and BPDU guard (or equivalent)
  C. fast transition to forwarding state
  D. backbone, uplink, and portfast (or equivalent)

• Question 170:

  You are using VTP (version 2) in your network to transport VLAN information between switches. When adding a switch to the network (that has been used in the lab previously), you notice that a lot of the existing VLANs have been deleted or replaced with other names.

  What can you do to prevent this from happening in the future, without losing all VTP features that you are using today?

  A. configure a hard-to-guess VTP domain name
  B. use a hard-to-guess VTP password
  C. use VTP transparent mode
  D. implement VTP version 3
  D. implement VTP version 3