1. Home
  2. Cisco
  3. 300-165

Cisco 300-165 Online Practice Questions and Exam Preparation

300-165 Exam Details

  • Exam Code
    :300-165
  • Exam Name
    :Implementing Cisco Data Center Infrastructure
  • Certification
    :Cisco Certifications
  • Vendor
    :Cisco
  • Total Questions
    :328 Q&As
  • Last Updated
    :Dec 15, 2021

Cisco 300-165 Online Questions & Answers

  • Question 81:

    You experience an issue on a Cisco Nexus 7700 Series switch. You must gather detailed information about the system state and the configuration of the switch. Which command should you run?

    A. switch# show logging > bootflash:Log.txt
    B. switch# show tech-support > bootflash:Log.txt
    C. switch# show running-config > bootflash:Log.txt
    D. switch# show system > bootflash:Log.txt

  • Question 82:

    Refer to the exhibit. What is the result of running the command?

    A. The startup config is backed up.
    B. The running config is backed up to the TFTP server by using a file named nexus-core-a-cfg.
    C. A timestamp is included in the name of the file that is backed up to the TFTP server.
    D. The default VRF is used to establish a connection to the TFTP server.

  • Question 83:

    When creating a VDC on a Cisco Nexus 7000 switch, which command in the VDC designates that only 10 port channels can be created in that VDC?

    A. allocate resource port-channel 10
    B. limit-resource port-channel minimum 0 maximum 10
    C. allow-resource port-channel maximum 10
    D. port-channel maximum 10

  • Question 84:

    You are connecting a Cisco Nexus 2300 Series FEX to a Cisco Nexus 5600 Series parent switch. Which command should you use to configure the interfaces on the Nexus switch that connects to the FEX?

    A. switch(config-if)# switchport mode f
    B. switch(config-if)# switchport mode fex-fabric
    C. switch(config-if)# switchport mode fabricpath
    D. switch(config-if)# switchport mode vntag

  • Question 85:

    Which option is supported when configuring a VACL?

    A. redirect to a SPAN destination port
    B. log of traffic that is matched by a VACL by using a MAC ACL
    C. egress VACL that contains decapsulated VXLAN traffic
    D. access map entry that uses an IP or MAC ACL

  • Question 86:

    Refer to the exhibit. Which statement about the configuration is true?

    A. The emulated switch ID is S30.
    B. The vPC+ domain ID must match on S30.
    C. The peer link is a FabricPath edge port.
    D. Packets to MAC A are using S100.

  • Question 87:

    Which statement about fabric binding is true?

    A. It can be distributed by CFS.
    B. It binds devices at the interface level.
    C. It learns about switches or devices that are logging in if learning mode is enabled.
    D. Binding is based on Switch World Wide Names and domain ID.

  • Question 88:

    Scenario

    The following four questions concern the Nexus 7010's which are configured as a vPC pair at the core of a Data Center network. You can utilize all the available show commands to answer the questions. Access to the running-configuration is

    not allowed.

    Instructions

    Enter NX-OS commands on 7K-3 and 7K-4 to verify network operation and answer four multiple-choice questions.

    THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.

    Click on the switch to gain access to the console of the switch. No console or enable passwords are required.

    To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.

    There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button.

    Within the vpc configuration of the 7K's, the command peer-switch is configured.

    What is the result of enabling this command?

    A. Both vPC peers use the same STP root ID
    B. The vPC primary switch (7K-4 in this case) also serves as the STP root to improve vPC convergence
    C. The vPC secondary switch (7K-3 in this case) serves as the STP root to improve vPC performance
    D. Allows 7K-3 to act as the active HSRP gateway for packets that are addressed to the MAC address of 7K-4
    E. Automatically disables IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the vPC peer gateway router
    F. Enables faster convergence of ARP tables after the vPC peer link flaps

  • Question 89:

    What are two prerequisites to running the Smart Call Home feature on a Cisco Nexus 6000 Series switch? (Choose two.)

    A. The switch must have SMTP access to an email server.
    B. The switch must have a public management IP address.
    C. The switch must have SMTP access to a Cisco.com email server.
    D. The switch must have an active service contract.
    E. The switch must be configured to use an email address from the @cisco.com domain.

  • Question 90:

    Which command allows a Cisco Nexus 7000 Series Switch to receive NTP configuration updates by using Cisco Fabric Services?

    A. N7k (config)# feature ntp
    B. N7k (config)# ntp distribute
    C. N7k (config)# distribute
    D. N7k (config)# ntp master

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 300-165 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.