Cisco 300-080 Online Practice Questions and Exam Preparation

Cisco 300-080 Online Questions & Answers

• Question 351:

  If you are required to configure a router to use MGCP on a digital port, which measure will you take?

  A. Add the application mgcpapp subcommand to the dial peer
  B. Add the service mgcp subcommand to the dial peer
  C. Add the parameter application mgcpapp to the ds0-group controller subcommand.
  D. Add the service mgcp parameter to the ds0-group controller subcommand
  D. Add the service mgcp parameter to the ds0-group controller subcommand

• Question 352:

  Partitions can be assigned to which item?

  A. directory numbers
  B. devices
  C. gateways
  D. IP phones
  A. directory numbers

• Question 353:

  Refer to the exhibit. These settings are configured on a Cisco TelePresence System EX90. What is the result?

  

  A. The endpoint successfully registers to Cisco Unified Communications Manager as a SIP endpoint.
  B. The endpoint does not register to Cisco VCS as a SIP endpoint, because the domain information is missing.
  C. The endpoint does not register to Cisco Unified Communications Manager as a SIP endpoint, because the domain information is missing.
  D. The endpoint successfully registers to Cisco VCS as a SIP endpoint.
  E. The endpoint successfully registers to Cisco Unified Communications Manager as an H.323 endpoint.
  F. The endpoint successfully registers to Cisco VCS as an H.323 endpoint.
  F. The endpoint successfully registers to Cisco VCS as an H.323 endpoint.

• Question 354:

  After you deploy a hardware transcoder, users without a common codec are unable to complete cafe to one another. Which two actions must you take (Choose two.)

  A. Use RTMT to verify mat transcoder resources are available
  B. verify that all SIP trunks are registered within Cisco Unified Communications Manager
  C. verify that media resources are assigned to the transcoder
  D. verify that the transcoder registered with Cisco Untied Communications Manage.
  E. verify that the transcoder is running the latest firmware and flash NVRAM
  A. Use RTMT to verify mat transcoder resources are available
  D. verify that the transcoder registered with Cisco Untied Communications Manage.

• Question 355:

  You configured a Cisco ISR G2 as a SIP gateway, but the gateway does not show that it is registered with Cisco Unified Communications Manager. What is causing this issue?

  A. Cisco Unified Communications Manager does not support SIP gateways.
  B. The gateway does not have the UC license installed.
  C. The gateway does not have Cisco Unified Border Element session licensing.
  D. Cisco Unified Communications Manager does not show a SIP gateway as registered if it is not properly configured.
  E. Cisco Unified Communications Manager never shows a SIP gateway as registered even when it is properly configured.
  F. The Cisco ISR G2 cannot be a SIP gateway.
  E. Cisco Unified Communications Manager never shows a SIP gateway as registered even when it is properly configured.

• Question 356:

  

  Refer to the exhibit. Intersite calls that are placed across the IP WAN are dialed with the on-net access code 8, followed by the one-digit site code and the four-digit extension of the called party. In order to preserve these dialing habits when

  the IP WAN is down and Cisco SRST is active, the internal numbers must be converted into E.164 numbers before sending them to the PSTN.

  Which configuration allows PSTN calls from the New York site to the San Jose site over the PSTN, while preserving the end user's six-digit dialing habit?

  

  A. Option A
  B. Option B
  C. Option C
  D. Option D
  B. Option B

• Question 357:

  When viewing the configuration of Intercluster Lookup Service, this command is used to look up the URl of a remote cluster user:

  Admin:utils ils lookup [email protected] Routing string is cucm1.cisco.com

  Which configuration is required on Cisco Unified Communications Manager, in order to allow routing calls to the URl of this remote cluster user?

  A. SIP route pattern for domain*.acme.com
  B. SIP trunk with destination cucm1.cisco.com
  C. end user with directory URl [email protected]
  D. SIP route pattern for domain*cisco.com
  A. SIP route pattern for domain*.acme.com

• Question 358:

  If a user receives a reorder tome after dialing a number, the Cisco Unified Communications Manager bandwidth allocation for the location of one of the call end devices may have been exceeded. Which option is true?

  A. If the call is using G.711, Cisco Unified CM subtracts 64k. If the call is using G.723, Cisco Unified CM subtracts 16k. If the call is using G.729, Cisco Unified CM subtracts 8k.
  B. If the call is using G.711, Cisco Unified CM subtracts 80k. If the call is using G.723, Cisco Unified CM subtracts 24k. If the call is using G.729, Cisco Unified CM subtracts 24k.
  C. If the call is using G.711, Cisco Unified CM subtracts 80k. If the call is using G.723, Cisco Unified CM subtracts 24k. If the call is using G.729, Cisco Unified CM subtracts 16k.
  D. If the call is using G.711, Cisco Unified CM subtracts 64k. If the call is using G.723, Cisco Unified CM subtracts 24k. If the call is using G.729, Cisco Unified CM subtracts 8k.
  B. If the call is using G.711, Cisco Unified CM subtracts 80k. If the call is using G.723, Cisco Unified CM subtracts 24k. If the call is using G.729, Cisco Unified CM subtracts 24k.

• Question 359:

  You recently configured a system for B2B SIP URI calls, and users confirmed that they could make calls. You are receiving multiple reports that inbound calls are failing and that users are not receiving calls to their URI. You confirm that all zones between expressways are active, and the trunk between Cisco Unified Communications Manager and Cisco VCS Expressway is active. You also see that the inbound call is sent from Cisco VCS Expressway C to Cisco Unified Communications Manager. Why are the calls failing?

  A. The Cisco Unified Communications Manager FQDN was not set.
  B. The cluster FQDN was not set in Enterprise Parameters.
  C. The certificate is not valid.
  D. The cluster FQDN was not set in Service Parameters.
  E. The FQDN was not registered in DNS.
  B. The cluster FQDN was not set in Enterprise Parameters.

• Question 360:

  Two Cisco Unified Communications Manager clusters have recently been installed. One is in Tokyo and the other in Chicago connected by a WAN link. You have started the configuration of a SIP trunk and you are integrating the dial plans. All phones in Tokyo can call all phones in Chicago, but no phones in Chicago can call Tokyo phones. Which two statements are possible causes? (Choose two.)

  A. The CSS of the Chicago phones does not include the partition of the route pattern to point to Tokyo.
  B. The SIP trunk in Chicago is in a CSS that is not in the partition of the Chicago phones.
  C. The Tokyo SIP trunk inbound CSS does not contain the partition of the Tokyo phones.
  D. Tokyo phones are in a CSS that is not in the partition of the route pattern to call from Tokyo to Chicago.
  E. The SIP trunk is configured from Tokyo to Chicago, but not from Chicago to Tokyo.
  A. The CSS of the Chicago phones does not include the partition of the route pattern to point to Tokyo.
  C. The Tokyo SIP trunk inbound CSS does not contain the partition of the Tokyo phones.