Cisco 200-301 Online Practice Questions and Exam Preparation

Cisco 200-301 Online Questions & Answers

• Question 1481:

  Why choose Cisco DNA Center for automated lifecycle management?

  A. to allow SSH access to ail nodes in the network
  B. to provide software redundancy in the network
  C. to perform upgrades without service interruption
  D. to provide fast and accurate deployment of patches and updates
  D. to provide fast and accurate deployment of patches and updates

• Question 1482:

  Refer to the exhibit.

  An administrator configures the following ACL in order to prevent devices on the 192.168.1.0 subnet from accessing the server at 10.1.1.5:

  

  Where should the administrator place this ACL for the most efficient use of network resources?

  A. inbound on router A Fa0/0
  B. outbound on router B Fa0/0
  C. outbound on router A Fa0/1
  D. inbound on router B Fa0/1
  A. inbound on router A Fa0/0

• Question 1483:

  Which QoS tool can you use to optimize voice traffic on a network that is primarily intended for data traffic?

  A. FIFO
  B. WFQ
  C. PQ
  D. WRED
  C. PQ

  ---

  Deciding Which Queueing Policy to Use

  PQ guarantees strict priority in that it ensures that one type of traffic will be sent, possibly at the expense of all others.

  Strict PQ allows delay-sensitive data such as voice to be dequeued and sent before packets in other queues are dequeued.

  https://www.cisco.com/c/en/us/td/docs/ios/qos/configuration/guide/12_2sr/qos_12_2sr_book/congstion_mgmt_oview.html

• Question 1484:

  Which effete does the aaa new-model configuration command have?

  A. It enables AAA services on the device.
  B. It configures the device to connect to a RADIUS server for AAA.
  C. It associates a RADIUS server to the group.
  D. It configures a local user on the device.
  A. It enables AAA services on the device.

  ---

  To enable AAA, you need to configure the aaa new-model command in global configuration.

  https://www.cisco.com/c/en/us/support/docs/security-vpn/terminal-access-controller-access-control-system-tacacs-/10384-security.html

• Question 1485:

  What are two requirements for an HSRP group? (Choose two.)

  A. exactly one active router
  B. one or more standby routers
  C. one or more backup virtual routers
  D. exactly one standby active router
  E. exactly one backup virtual router
  A. exactly one active router
  B. one or more standby routers

  ---

  Exactly one active router: Only one Active Router per HSRP group will be elected based on highest priority. In case of equal priority, Highest IP address will be elected as Active Router. One or more standby routers: There can be one or more Standby Routers.

• Question 1486:

  Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?

  A. The link becomes an access port.
  B. The link is in an error disabled state.
  C. The link is in a down state.
  D. The link becomes a trunk port.
  D. The link becomes a trunk port.

  ---

  Dynamic Auto -- Makes the Ethernet port willing to convert the link to a trunk link. The port becomes a trunk port if the neighboring port is set to trunk or dynamic desirable mode. This is the default mode for some switchports. Dynamic Desirable -- Makes the port actively attempt to convert the link to a trunk link. The port becomes a trunk port if the neighboring Ethernet port is set to trunk, dynamic desirable or dynamic auto mode.

• Question 1487:

  Which switch port configuration must be configured when connected to an AP running in FlexConnect mode, and the WLANs use flex local switching?

  A. access port with one VLAN
  B. trunk port with pruned VLANs
  C. Layer 3 port with an IP address
  D. tagged port with MAC Filtering enabled
  B. trunk port with pruned VLANs

• Question 1488:

  DRAG DROP

  Drag and drop the IPv6 addresses from the left onto the corresponding address types on the right.

  Select and Place:

  

  

• Question 1489:

  What is represented beginning with line 1 and ending with line 5 within this JSON schema?

  

  A. key
  B. object
  C. array
  D. value
  C. array

• Question 1490:

  Which interface is used to send traffic to the destination network?

  10.90.207.87/26 [110/1912] via F0/7

  10.90.207.87/26 [110/28968] via F0/6

  10.90.207.87/26 [120/14] via F0/4

  10.90.207.87/26 [120/11] via F0/5

  A. F0/7
  B. F0/5
  C. F0/4
  D. F0/6
  A. F0/7