Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 1171:

  Which two Cisco IOS commands, used in troubleshooting, can enable debug output to a remote location? (Choose two)

  A. no logging console
  B. logging host ip-address
  C. terminal monitor
  D. show logging | redirect flashioutput.txt
  E. snmp-server enable traps syslog
  B. logging host ip-address
  C. terminal monitor

• Question 1172:

  Correct Answer. Check the answer below

  Check the answer below

  ---

  

  

  Step1

  enable conf t ipv6 unicast-routing ipv6 route ::/0 2001: DB8:B:B1B2::1

  Step2

  Ipv6 router ospf 100 Default-information originate end

  Step3

  interface s1/0 Ipv6 ospf 100 area 0 end

  Step4

  copy run start

• Question 1173:

  Which statement describes the process of dynamically assigning IP addresses by the DHCP server?

  A. Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.
  B. Addresses are permanently assigned so that the hosts uses the same address at all times.
  C. Addresses are assigned for a fixed period of time, at the end of the period, a new request for an address must be made.
  D. Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.
  D. Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.

  ---

  The DHCP lifecycle consists of the following: Allocation: A client begins with no active lease, and hence, no DHCP-assigned address. It acquires a lease through a process of allocation. Reallocation: If a client already has an address from an existing lease, then when it reboots or starts up after being shut down, it will contact the DHCP server that granted it the lease to confirm the lease and acquire operating parameters. This is sometimes called reallocation; it is similar to the full allocation process but shorter. Normal Operation: Once a lease is active, the client functions normally, using its assigned IP address and other parameters during the "main part" of the lease. The client is said to be bound to the lease and the address. Renewal: After a certain portion of the lease time has expired, the client will attempt to contact the server that initially granted the lease, to renew the lease so it can keep using its IP address. Rebinding. If renewal with the original leasing server fails (because, for example, the server has been taken offline), then the client will try to rebind to any active DHCP server, trying to extend its current lease with any server that will allow it to do so. Release: The client may decide at any time that it no longer wishes to use the IP address it was assigned, and may terminate the lease, releasing the IP address.

• Question 1174:

  Drag and Drop

  Select and Place:

  

  

• Question 1175:

  Which two statements about PAP authentication in a PPP environment are true? (Choose two)

  A. It is performed at the beginning of the session only.
  B. It hashes the password before sending it.
  C. It sends the password in clear text.
  D. It is performed at the beginning of the session and is repeated periodically for as long as the session is maintained
  E. It uses a username with an MD5 password to authenticate
  A. It is performed at the beginning of the session only.
  C. It sends the password in clear text.

• Question 1176:

  Which technique can you use to route IPv6 traffic over an IPv4 infrastructure?

  A. NAT
  B. 6to4 tunneling
  C. L2TPv3
  D. dual-stack
  B. 6to4 tunneling

• Question 1177:

  What are two requirements for an HSRP group? (Choose two.)

  A. exactly one active router
  B. one or more standby routers
  C. one or more backup virtual routersvv
  D. exactly one standby active routerv
  E. exactly one backup virtual router
  A. exactly one active router
  D. exactly one standby active routerv

• Question 1178:

  Which two technologies can combine multiple physical switches into one logical switch? (Choose two.)

  A. StackWise
  B. VSS
  C. VRRP
  D. GLBP
  E. HSRP
  A. StackWise
  B. VSS

• Question 1179:

  Which command can you enter to verify that a 128-bit address is live and responding?

  A. traceroute
  B. telnet
  C. ping
  D. show ipv6
  C. ping

• Question 1180:

  Which keyword enables an HSRP router to take the active role immediately when it comes online?

  A. IP address
  B. Priority
  C. Preempt
  D. Version
  C. Preempt