Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 1191:

  Which standards-based First Hop Redundancy Protocol is a Cisco supported alternative to Hot Standby Router Protocol?

  A. VRRP
  B. GLBP
  C. TFTP
  D. DHCP
  A. VRRP

• Question 1192:

  Syslog was configured with a level 3 trap. Which 3 types of logs would be generated (choose four)

  A. Emergencies
  B. Alerts
  C. Critical
  D. Errors
  E. Warnings
  A. Emergencies
  B. Alerts
  C. Critical
  D. Errors

  ---

  The Message Logging is divided into 8 levels as listed below:

  Level Keyword Description 0 emergencies System is unusable 1 alerts Immediate action is needed 2 critical Critical conditions exist 3 errors Error conditions exist 4 warnings Warning conditions exist 5 notification Normal, but significant, conditions exist 6 informational Informational messages 7 debugging Debugging messages

  The highest level is level 0 (emergencies). The lowest level is level 7. If you specify a level with the "logging console level" command, that level and all the higher levels will be displayed. For example, by using the "logging console warnings" command, all the logging of emergencies, alerts, critical, errors, warnings will be displayed.

• Question 1193:

  In which two circumstances are private IPv4 addresses appropriate? (Choose two)

  A. on internal hosts that stream data solely to external resources
  B. on hosts that communicates only with other internal hosts
  C. on the public-facing interface of a firewall
  D. on hosts that require minimal access to external resources
  E. to allow hosts inside an enterprise to communicate in both directions with hosts outside the enterprise
  B. on hosts that communicates only with other internal hosts
  D. on hosts that require minimal access to external resources

• Question 1194:

  How can you disable DTP on a switch port?

  A. Configure the switch port as a trunk.
  B. Add an interface on the switch to a channel group.
  C. Change the operational mode to static access.
  D. Change the administrative mode to access.
  D. Change the administrative mode to access.

• Question 1195:

  Which of the following is needed to be enable back the role of active in HSRP?

  A. preempt
  B. priority
  A. preempt

• Question 1196:

  Which two statements about configuring an EtherChannel on a Cisco switch are true? (Choose two.)

  A. The interfaces configured in the EtherChannel must be on the same physical switch.
  B. The interfaces configured in the EtherChannel must operate at the same speed and duplex mode
  C. An EtherChannel can operate in Layer 2 mode only.
  D. The interfaces configured in the EtherChannel must be part of the same VLAN or trunk.
  E. The interfaces configured in the EtherChannel must have the same STP port path cost
  B. The interfaces configured in the EtherChannel must operate at the same speed and duplex mode
  D. The interfaces configured in the EtherChannel must be part of the same VLAN or trunk.

• Question 1197:

  Which statemnet about ACLs is true?

  A. An ACL have must at least one permit action, else it just blocks all traffic
  B. ACLs go bottom-up through the entries looking for a match
  C. An ACL has a an implicit permit at the end of ACL
  D. ACLs will check the packet against all entries looking for a match
  A. An ACL have must at least one permit action, else it just blocks all traffic

• Question 1198:

  If you want multiple hosts on a network, where do you configure the setting?

  A. in the IP protocol
  B. in the multicast interface
  C. in the serial interface
  D. in the global configuration
  A. in the IP protocol

• Question 1199:

  Users complain that they are unable to reach internet sites. You are troubleshooting internet connectivity problem at main office.

  

  Which statement correctly identifies the problem on Router R1?

  A. NAT configurations on the interfaces are incorrectly configured.
  B. NAT translation statement incorrectly configured.
  C. Interesting traffic for NAT ACL is incorrectly configured.
  D. Only static NAT translation configured from the server, missing Dynamic NAT or Dynamic NAT overloading for internal networks.
  A. NAT configurations on the interfaces are incorrectly configured.

• Question 1200:

  On a live network, which two commands will verify the operational status of router interfaces? (Choose two.)

  A. Router# show ip interface brief
  B. Router# debug interface
  C. Router# show ip protocols
  D. Router# show interfaces
  E. Router# show start
  A. Router# show ip interface brief
  D. Router# show interfaces