Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 1311:

  Which two approaches are common when troubleshooting network issues? (Choose two.)

  A. round-robin
  B. divide and conquer
  C. policing
  D. top down
  E. layer-by-layer
  B. divide and conquer
  D. top down

• Question 1312:

  Refer to the exhibit.

  

  RTA is configured with a basic configuration. The link between the two routers is operational and no routing protocols are configured on either router. The line shown in the exhibit is then added to router RTA. Should interface Fa0/0 on router RTB shut down, what effect will the shutdown have on router RTA?

  A. A route to 172.16.14.0/24 will remain in the RTA routing table.
  B. Because router RTB will send a poison reverse packet to router RTA, RTA will remove the route.
  C. Router RTA will send an ICMP packet to attempt to verify the route.
  D. A packet to host 172.16.14.225 will be dropped by router R.
  A. A route to 172.16.14.0/24 will remain in the RTA routing table.

• Question 1313:

  Which two statements about the APIC-EM ACL Trace tool are true? (Choose two)

  A. Traffic analysis is performed for an entire path from source to destination, even if an ACL along the path would have blocked the actual traffic
  B. It analyzes egress traffic flow only
  C. It can analyze ingress and egress traffic flows
  D. It can ACL along the path from source to destination would have blocked the actual traffic, the traffic analysis stops at that ACL.
  E. If traffic matches more than one entry in a single ACL, higher and lower priority entries are applied
  C. It can analyze ingress and egress traffic flows
  D. It can ACL along the path from source to destination would have blocked the actual traffic, the traffic analysis stops at that ACL.

• Question 1314:

  Which two are displayed with the show ipv6 ospf command? (Choose two)

  A. transmit and receive rates of each local interface
  B. OSPF interface of the local router
  C. number of interfaces in each area on the device
  D. number of times the SPF algorithm executed on the device
  E. ID of the advertised router
  C. number of interfaces in each area on the device
  D. number of times the SPF algorithm executed on the device

• Question 1315:

  What is the correct routing match to reach 172.16.1.5/32?

  A. 172.16.1.0/26
  B. 172.16.1.0/25
  C. 172.16.1.0/24
  D. the default route
  A. 172.16.1.0/26

• Question 1316:

  Which 2 statements about extended traceroute command is true?

  A. it can send packets from specified interface or ip address
  B. it can use a specified TTL value.
  C. it can validate the reply data.
  D. it can use a specificed TOS.
  E. it can repeated automatically to a specified interval.
  A. it can send packets from specified interface or ip address
  B. it can use a specified TTL value.

  ---

  Reference:

  http://www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/13730- extpingtrace.

  html#ext_troute

  "This table lists the traceroute command field descriptions:

  Source address: The interface or IP address of the router to use as a source address for the probes. The

  router normally picks the IP address of the outbound interface to use.

  Minimum Time to Live [1]: The TTL value for the first probes. The default is 1, but it can be set to a higher

  value to suppress the display of known hops.

  Maximum Time to Live [30]: The largest TTL value that can be used. The default is 30. The traceroute

  command terminates when the destination is reached or when this value is reached.