Cisco 100-105 Online Practice Questions and Exam Preparation

Cisco 100-105 Online Questions & Answers

• Question 411:

  If NVRAM lacks boot system commands, where does the router look for the Cisco IOS by default?

  A. ROM
  B. RAM
  C. Flash
  D. bootstrap
  E. startup-config
  C. Flash

• Question 412:

  Which statement about the ipv6 enable interface mode command is true?

  A. It allows the administrator to manually assign an IPv6 address to the interface.
  B. It disables IPv4 addresses on the interface.
  C. It dynamically assigns an IPv6 link-local address to the interface based on router advertisements.
  D. It dynamically assigns an IPv6 link-local address to the interface based on the MAC address of the interface.
  D. It dynamically assigns an IPv6 link-local address to the interface based on the MAC address of the interface.

• Question 413:

  What is the best practice when assigning IP addresses in a small office of six hosts?

  A. Use a DHCP server that is located at the headquarters.
  B. Use a DHCP server that is located at the branch office.
  C. Assign the addresses by using the local CDP protocol.
  D. Assign the addresses statically on each node.
  D. Assign the addresses statically on each node.

• Question 414:

  Which cloud service is typically used to provide DNS and DHCP services to an enterprise?

  A. IaaS
  B. DaaS
  C. SaaS
  D. PaaS
  C. SaaS

• Question 415:

  Refer to the exhibit. A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?

  

  A. Host B would not be able to access the server in VLAN9 until the cable is reconnected.
  B. Communication between VLAN3 and the other VLANs would be disabled.
  C. The transfer of files from Host B to the server in VLAN9 would be significantly slower.
  D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume.
  D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume.

• Question 416:

  Instructions

  For both the Router and the Switch the simulated console mode needs to start and remain in enabled mode.

  RouterA and SwitchA have been configured to operate in a private network which will connect to the Internet. You have been asked to review the configuration prior to cabling and implementation.

  This task requires the use of various IOS commands to access and inspect the running configuration of RouterA and SwitchA. No configuration changes are necessary.

  You will connect to RouterA and SwilchA via the console devices that are attached to each.

  There are 4 multiple-choice questions with this task. Be sure to answer all of them before leaving this item. In order to score the maximum points you will need to have accessed both SwitchA and RouterA.

  NOTE: The configuration command has been disabled for both the router and switch in this simulation.

  

  Which two of the following are true regarding the configuration of RouterA? (Choose two.)

  A. at least 5 simultaneous remote connections are possible
  B. only telnet protocol connections to RouterA are supported
  C. remote connections to RouterA using telnet will succeed
  D. console line connections will never time out due to inactivity
  E. since DHCP is not used on Fa0/1 there is no need to use the NAT protocol
  A. at least 5 simultaneous remote connections are possible
  C. remote connections to RouterA using telnet will succeed

• Question 417:

  In which circumstance is static routing most useful?

  A. on a stub network
  B. on a network with frequent routing changes
  C. on a network that experiences frequent link failures
  D. on a large network that must share routes quickly between routers
  A. on a stub network

• Question 418:

  What is the subnet address of 192.168.1.42 255.255.255.248?

  A. 192.168.1.16/28
  B. 192.168.1.32/27
  C. 192.168.1.40/29
  D. 192.168.1.8/29
  E. 192.168.1.48/29
  C. 192.168.1.40/29

• Question 419:

  Given a Class C IP address subnetted with a /30 subnet mask, how many valid host IP addresses are available on each of the subnets?

  A. 1
  B. 2
  C. 4
  D. 8
  E. 252
  F. 254
  B. 2

• Question 420:

  The network administrator is using a Windows PC application that is called putty.exe for remote communication to a switch for network troubleshooting. Which two protocols could be used during this communication? (Choose two).

  A. SNMP
  B. HTTP
  C. Telnet
  D. RMON
  E. SSH
  C. Telnet
  E. SSH