Cisco 100-105 Online Practice Questions and Exam Preparation

Cisco 100-105 Online Questions & Answers

• Question 191:

  Which two pieces of information can be shared with LLDP TLVs? (Choose two)

  A. device management address.
  B. device type
  C. spanning-tree topology
  D. routing configuration
  E. access-list configuration
  A. device management address.
  B. device type

• Question 192:

  Which value does RIPv2 use to calculate its route metric?

  A. delay
  B. bandwidth
  C. hop count
  D. reliability
  C. hop count

• Question 193:

  Which sequence begins a unique local IPv6 address in binary notation?

  A. 1111110
  B. 1111111
  C. 00000000
  D. 1111100
  A. 1111110

• Question 194:

  From which of the following attacks can Message Authentication Code (MAC) shield your network?

  A. DoS
  B. DDoS
  C. spoofing
  D. SYN floods
  C. spoofing

• Question 195:

  Which three statements about DWDM are true? (Choose three)

  A. It allows a single strand of fiber to support bidirectional communications
  B. It is used for long-distance and submarine cable systems
  C. It can multiplex up to 256 channels on a single fiber
  D. It supports both the SDH and SONET standards
  E. Each channel can carry up to a 1-Gbps signal
  F. It supports simplex communications over multiple strands of fiber
  C. It can multiplex up to 256 channels on a single fiber
  D. It supports both the SDH and SONET standards
  E. Each channel can carry up to a 1-Gbps signal

• Question 196:

  Which IPv4 address type is used to communicate with all hosts on a subnet?

  A. broadcast
  B. link-local
  C. anycast
  D. multicast
  D. multicast

• Question 197:

  Which statement about unicast frame forwarding on a switch is true?

  A. The TCAM table stores destination MAC addresses.
  B. If the destination MAC address is unknown, the frame is flooded to every port that is configured in the same VLAN except on the port that it was received on.
  C. The CAM table is used to determine whether traffic is permitted or denied on a switch.
  D. The source address is used to determine the switch port to which a frame is forwarded.
  B. If the destination MAC address is unknown, the frame is flooded to every port that is configured in the same VLAN except on the port that it was received on.

• Question 198:

  Which set of conditions comprises a successful ping attempt between two connected routers configured with IP addresses on the same subnet?

  A. The destination host receives an echo reply from the source host within one second and the source host receives an echo request from the destination host.
  B. The destination host receives an echo request from the source host within one second.
  C. The destination host receives an echo reply from the source host within one second and the source host receives an echo reply from the destination host within two seconds.
  D. The destination host receives an echo request from the source host and the source host receives an echo request from the destination host within one second.
  E. The destination host receives an echo request from the source host and the source host receives an echo reply from the destination host within two seconds.
  E. The destination host receives an echo request from the source host and the source host receives an echo reply from the destination host within two seconds.

• Question 199:

  DRAG DROP

  Drag and drop the TCP/IP protocols from the left onto the correct transmission protocols on the right.

  Select and Place:

  

  

• Question 200:

  A router is deployed with the default factory settings. If a user on the router mistypes a command, which option is the result?

  A. The router immediately returns an error message.
  B. The router recognizes the mistake and discards the request.
  C. The router autocorrects the mistyped command.
  D. The router attempts to resolve the command to an IP address.
  E. The router disables DNS lookup.
  D. The router attempts to resolve the command to an IP address.