NetApp NS0-504 Online Practice Questions and Exam Preparation

NetApp NS0-504 Online Questions & Answers

• Question 381:

  For access to a VMFS datastore created on a NetApp LUN on an ESX 4.0 system for an ALUA configuration, the path selection policy should be set to:

  A. MRU (Most Recently Used)
  B. Fixed
  C. RR (Round Robin)
  D. ALUA
  C. RR (Round Robin)

• Question 382:

  During a cluster failover operation (CFO), paths on the surviving node of the HA pair will show as:

  A. Non Optimized
  B. Indirect
  C. Direct
  D. Asymmetric
  C. Direct

• Question 383:

  To remove a cluster setup, you must perform these steps:

  1.

  Type cf disable.

  2.

  Unlicense cluster.

  3.

  Remove partner entries for network interfaces from the /etc/rc file.

  4.

  Halt and make sure the partner-sysid is blank.

  5.

  Power down and remove the cluster interconnect card.

  6.

  Perform steps 1-5 above on the partner node.

  A. True
  B. False
  A. True

• Question 384:

  When running clustered Data ONTAP, which topology allows for guaranteed maximum network performance for iSCSI?

  A. WAN network
  B. VLAN network
  C. MetroWAN network
  D. Isolated VSAN network
  B. VLAN network

• Question 385:

  With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is ____.

  A. 500
  B. 1000
  C. 6400
  D. 64000
  A. 500

• Question 386:

  Click the Exhibit button.

  

  In the cabinet diagram shown, what additional information should be included to make it more complete?

  A. switch connectivity
  B. storage port connectivity
  C. storage shelf connectivity
  D. storage controller rack placement
  C. storage shelf connectivity

• Question 387:

  What are two possible impacts to consider when changing the cfmode to single_image?. (Choose two.)

  A. There more paths to LUNs.
  B. Target port WWPNs will change on at least one controller.
  C. You must use hard zoning (zoning by ports).
  D. There are fewer paths to LUNs.
  E. hosts running Solaris since it does not support single_image cfmode
  A. There more paths to LUNs.
  B. Target port WWPNs will change on at least one controller.

• Question 388:

  Which task is part of the site preparation for installation?

  A. configure zoning
  B. install equipment in rack
  C. verify equipment move path
  D. verify host to storage connectivity
  C. verify equipment move path

• Question 389:

  NetApp recommends that Fibre Channel switches that have both disk and tape connected to them should have separate zones created for each.

  A. True
  B. False
  A. True

• Question 390:

  How does a host determine the new state of an ALUA path?

  A. It sends a path status API call to the cluster management Interface
  B. It receives a LOGICAL UNIT NOT READY response from that path.
  C. It sends a SCSI INQUIRY command.
  D. It receives an indirect path notification from the attached FC or Ethernet switch.
  C. It sends a SCSI INQUIRY command.