HP HP2-T26 Online Practice Questions and Exam Preparation

HP HP2-T26 Online Questions & Answers

• Question 211:

  How many power supplies are needed for an (N+N) configuration in a c7000 enclosure?

  A. 3
  B. 4
  C. 5
  D. 7
  B. 4

• Question 212:

  What happens during a Virtual Connect configuration restore?

  A. The configuration restores without causing any service interruption to the server blades.
  B. There is service interruption during the restore of the configuration.
  C. A reboot of the entire enclosure is required for the new configuration to take effect.
  D. A reboot of the Onboard Administrator is required in order to re-establish communication to the Virtual Connect module.
  C. A reboot of the entire enclosure is required for the new configuration to take effect.

• Question 213:

  Which firmware can be upgraded using HP SUM running on a Windows-based ProLiant?

  A. Intel NIC
  B. Emulex Fibre HBA
  C. HP SAS hard drive not connected to Smart Array Controller
  D. HP SATA hard drive not connected to Smart Array Controller
  B. Emulex Fibre HBA

• Question 214:

  Your customer uses a c3000 enclosure with only one Virtual Connect Flex 10 module in bay 1. The Virtual Connect firmware needs to be updated and you are in the process of writing an action plan for this process. Which information needs to be included in this action plan?

  A. download location of the firmware
  B. information for possible elevation
  C. Statement of Work
  D. Virtual Connect Troubleshooting Guide
  D. Virtual Connect Troubleshooting Guide

• Question 215:

  Which memory tests can be run using HP Insight Diagnostics Offline Edition? (Select three.)

  A. loop
  B. complete
  C. quick
  D. random
  E. custom
  B. complete
  C. quick
  E. custom

• Question 216:

  When installing half-height c-Class server blades in a c3000 rack enclosure, what is the recommended sequence for installing them into the server bays when viewed from the front of the enclosure?

  A. from top to bottom, then right to left
  B. from bottom to top, then right to left
  C. from top to bottom, then left to right
  D. from bottom to top, then left to right
  D. from bottom to top, then left to right

• Question 217:

  What happens when you mix low-reduced DIMMs (LRDIMM) and unbuffered DIMMs (UDIMM)?

  A. The blade server will not boot up.
  B. The blade server boots up in a loop mode.
  C. The blade server boots up normally if you do not mix the DIMMS in the same bank.
  D. The blade server boots up normally.
  A. The blade server will not boot up.

• Question 218:

  What must be used to update Virtual Connect firmware above version 3.0x when VCEM is used and managing other domains?

  A. VCM
  B. HP SUM Offline
  C. VCSU
  D. HP FDT
  C. VCSU

• Question 219:

  Which HP tools should be used to determine that an SSD drive has degraded due to a high number of write operations? (Select three.)

  A. Array Configuration Utility
  B. Array Diagnostic Utility
  C. Option ROM Configuration for Arrays
  D. SmartSSD Wear Utility
  E. ROM Based Setup utility
  A. Array Configuration Utility
  B. Array Diagnostic Utility
  D. SmartSSD Wear Utility

• Question 220:

  A customer is having intermittent system problems a short time after deploying a new server blade. Which action should you take?

  A. Open a case with HP Technical Support.
  B. Replace the system board.
  C. Replace the system memory.
  D. Update the firmware to the latest levels.
  D. Update the firmware to the latest levels.