Skip to main content

DES-1241 Real Exam Questions

Specialist - Platform Engineer, PowerStore

98 questions available · Page 1 of 10

Updated Exam DumpsVerified AnswersPass Guarantee

Get Complete Exam Dumps
Question 1 Single choice

A Storage Administrator needs to connect through SSH to run svc commands.

How is the SSH session configured?

  1. A

    Appliance IP address using port 22

  2. B

    NAS server IP address using port 26

  3. C

    NAS server IP address using port 22

  4. D

    Appliance IP address using port 26

Show answer and explanation

Correct answer: C

Question 2 Single choice

Which component is hot-swappable?

  1. A

    SFP

  2. B

    Fan

  3. C

    BBU

  4. D

    Expansion IO module

Show answer and explanation

Correct answer: D

Explanation

References:
https://topics-cdn.dell.com/pdf/pwrstr-hwg_en-us.pdf
(15)

Question 3 Single choice

Refer to the exhibit.

What is indicated when the circled LED on the base enclosure is illuminated amber?

  1. A

    Base enclosure power-on

  2. B

    Cluster discovery state

  3. C

    Cluster service mode

  4. D

    Base enclosure fault

Show answer and explanation

Correct answer: A

Question 4 Single choice

What is the maximum number of base enclosures in a cluster when planning a Dell EMC PowerStore T installation?

  1. A

    1

  2. B

    2

  3. C

    3

  4. D

    4

Show answer and explanation

Correct answer: D

Explanation

References:
https://www.dellemc.com/en-us/collaterals/unauth/white-papers/products/storage/h18149-dell-emc-powerstore-platform-introduction.pdf

Question 5 Single choice

A Storage Administrator has an existing single appliance Dell EMC PowerStore 3000T cluster. An additional PowerStore 9000T has been purchased to add into the existing cluster.

How does the administrator proceed?

  1. A

    Additional VLTi links on the ToR switching must be configured for the 9000T to support the increased

    inter-switch network load

  2. B

    Add the new 9000T appliance into the cluster per the procedure; mixed models of the same type are
    supported

  3. C

    Remove two of the four NVMe NVRAM drives from the 9000T the caching configuration of all clustered appliances must match

  4. D

    The new appliance cannot be added to the cluster; appliance model and type must match when
    clustering appliances together

Show answer and explanation

Correct answer: A

Question 6 Single choice

From where can a data collection be initiated within Dell EMC PowerStore Manager?

  1. A

    Appliance, node, and storage resource

  2. B

    Cluster, appliance, and alerts

  3. C

    Cluster, appliance, and event log

  4. D

    Node, storage resource, and alerts

Show answer and explanation

Correct answer: A

Question 7 Single choice

Refer to the exhibit.

What is the result of the network configuration show for a Dell EMC PowerStore T node A management port?

  1. A

    VLAN 1 and VLAN 1501 pass tagged traffic

  2. B

    VLAN 1 passes tagged traffic, VLAN 1501 passes untagged traffic

  3. C

    VLAN 1 passes untagged traffic, VLAN 1501 passes tagged traffic

  4. D

    VLAN 1 and VLAN 1501 pass untagged traffic

Show answer and explanation

Correct answer: D

Question 8 Single choice

Refer to the exhibit.

A Storage Administrator noticed a solid amber LED.

What does this mean?

  1. A

    Drive identification on

  2. B

    Drive rebuilding

  3. C

    Power up

  4. D

    Drive faulted

Show answer and explanation

Correct answer: D

Explanation

References:
https://www.dell.com/support/article/en-pk/sln321266/powerstore-understanding-led-colors-and-states-for-troubleshooting?lang=en

Question 9 Single choice

A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster.

What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?

  1. A

    All the needed management IP addresses for the new appliance must be pre-configured on the cluster

  2. B

    Additional appliance does not require a cluster management IP address

  3. C

    Additional appliance inherits all its management IPs from the existing appliance

  4. D

    All the needed management IP addresses for the new appliance are auto-generated by the cluster

Show answer and explanation

Correct answer: D

Question 10 Single choice

Which Dell EMC PowerStore network uses an appliance backplane?

  1. A

    ICD

  2. B

    MPIO

  3. C

    Inter-node

  4. D

    Inter-cluster management

Show answer and explanation

Correct answer: C

Explanation

References:
https://blocksandfiles.com/2020/05/05/dell-emc-powerstore-midrange-array-launch-analysis/