Cisco 642-737 Online Practice Questions and Exam Preparation

Cisco 642-737 Online Questions & Answers

• Question 61:

  What is the maximum number of ACLs that can be applied to a Cisco WLC v7.0 interface?

  A. 1
  B. 16
  C. 32
  D. 64
  A. 1

• Question 62:

  When do NAC out-of-band deployments require user traffic to traverse through the Cisco NAC Server?

  A. posture assessment only
  B. 802.1X and EAP authentication and remediation
  C. posture assessment and remediation
  D. 802.1X and EAP authentication, posture assessment, and remediation
  C. posture assessment and remediation

• Question 63:

  Which three parameters can be communicated between a Cisco WLC v7.0 and Cisco Compatible Extensions v4-enabled client to improve a secure roaming connection? (Choose three.)

  A. minimum SNR
  B. transition time
  C. scan threshold
  D. hysteresis
  E. PER
  F. MIC errors
  B. transition time
  C. scan threshold
  D. hysteresis

• Question 64:

  The customer requires the use of the data, voice, barcode scanner, and guest WLANs. How many VLANs does Cisco recommend to be used?

  A. 1
  B. 2
  C. 3
  D. 4
  E. 5
  D. 4

• Question 65:

  Which two fast roaming algorithms will allow a WLAN client to roam to a new AP and re- establish a new session key without a full reauthentication of the WLAN client? (Choose two.)

  A. PMK
  B. PTK
  C. MIC
  D. GTK
  E. CKM
  F. PKC
  E. CKM
  F. PKC

• Question 66:

  Refer to the exhibit.

  

  A client reports being unable to log into the wireless network. According to the output, which network information should be verified?

  A. the Failed Attempts log on the authentication server
  B. that the client certificate is installed and configured correctly
  C. that the AP has IP connectivity to the authentication server
  D. that the authentication service is running and functional
  E. that the authentication and accounting configuration are correct
  F. that the user has an account on the authentication server
  A. the Failed Attempts log on the authentication server

• Question 67:

  Which device performs the enforcement of posture assessment for a wireless client when implementing a NAC appliance solution?

  A. Cisco NAC Guest Server
  B. Cisco Secure Access Control System
  C. Cisco 802.1X supplicant
  D. Cisco NAC Appliance Agent
  E. Cisco NAC Appliance Manager
  F. Cisco NAC Appliance Server
  G. Cisco IPS Appliance
  F. Cisco NAC Appliance Server

• Question 68:

  Which three WLAN polices can be controlled by using the Cisco IBNS on the Cisco WLC and Cisco Secure ACS? (Choose three.)

  A. QoS setting
  B. VLAN
  C. EAP type
  D. ACL
  E. authentication priority order
  F. NAC state
  A. QoS setting
  B. VLAN
  D. ACL

• Question 69:

  How is the MSE enabled to support wIPS service?

  A. CLI console or SSH session with the MSE
  B. HTTPS with the MSE
  C. HTTPS with the Cisco WCS to enable the MSE and WLC(s)
  D. HTTPS with WLC(s) to enable locally and the IP address of MSE
  C. HTTPS with the Cisco WCS to enable the MSE and WLC(s)

• Question 70:

  An engineer has configured passive fallback mode for RADIUS with default timer settings. What will occur when the primary RADIUS fails then recovers?

  A. RADIUS requests will be sent to the secondary RADIUS server until the secondary fails to respond.
  B. The controller will immediately revert back after it receives a RADIUS probe from the primary server.
  C. After the inactive time expires the controller will send RADIUS to the primary.
  D. Once RADIUS probe messages determine the primary controller is active the controller will revert back to the primary RADIUS.
  C. After the inactive time expires the controller will send RADIUS to the primary.