Cisco 642-732 Online Practice Questions and Exam Preparation

Cisco 642-732 Online Questions & Answers

• Question 181:

  What is the minimum CCX version necessary on a client when adding data points during WCS Calibration?

  A. CCXv1
  B. CCXv2
  C. CCXv3
  D. CCXv4
  E. CCXv5
  B. CCXv2

• Question 182:

  Which two issues can commonly create problems with positioning an antenna on a rooftop? (Choose two.)

  A. Reflection from the rooftop
  B. Absorption from the rooftop
  C. Fresnel obstruction from rooftop edge
  D. Lack of PoE for AP
  E. Other antennas
  C. Fresnel obstruction from rooftop edge
  E. Other antennas

• Question 183:

  Which three post-installation checks should an engineer perform after a new wireless installation? (Choose three.)

  A. Check for co-channel interference.
  B. Check for adequate signal levels as surveyed.
  C. Conduct a passive survey of 802.11a and 802.11b.
  D. Conduct a passive and active survey of each media type in use.
  E. Verify that the minimum data rate is 24 Mbps.
  F. Verify that the cell overlap is 20%.
  A. Check for co-channel interference.
  B. Check for adequate signal levels as surveyed.
  D. Conduct a passive and active survey of each media type in use.

• Question 184:

  Which two options indicate the RF channels regulated by 802.1h for outdoor deployment regarding FCC? (Choose two.)

  A. 36, 40, 44, 48
  B. 52, 56, 60, 64
  C. 100, 104, 108, 112
  D. 149, 153, 157, 161
  E. 165
  B. 52, 56, 60, 64
  C. 100, 104, 108, 112

• Question 185:

  On which two items will data be collected when an engineer is conducting a passive survey? (Choose two.)

  A. RF interference
  B. rate shifting data rates
  C. roaming
  D. rouges
  E. encryption
  A. RF interference
  D. rouges

• Question 186:

  DRAG DROP

  Select and Place:

  

  

• Question 187:

  Which three components and tasks should be considered while planning the site survey? (Choose three.)

  A. Determine the project scope, type of deployment, timeline, scale, budget, and users
  B. Determine project stakeholders
  C. Determine customer training requirements
  D. Determine AP and controller placement
  E. Determine the customer applications that the network will support
  F. Determine radio spectrum and channel allocation
  G. Schedule customer end user interviews
  A. Determine the project scope, type of deployment, timeline, scale, budget, and users
  B. Determine project stakeholders
  E. Determine the customer applications that the network will support

• Question 188:

  Which two details are specified in the Executive Summary section of the Site Survey Report? (Choose two.)

  A. proposed location for each AP
  B. customer and site surveyor contact details
  C. total number of APs
  D. expressed requirements set by customer
  E. coverage map
  C. total number of APs
  D. expressed requirements set by customer

• Question 189:

  An engineer has WLC redundancy included in WLAN design documentation, where the WLCs are loaded to half the license capacity therefore allowing half the WLCs to fail without an AP going offline at a given time. What redundancy model does this describe?

  A. N+1
  B. N+N
  C. N+N+1
  D. N+1+1
  B. N+N

• Question 190:

  You are working with a client that owns a six-story building in Charlotte, N.C. They occupy the bottom three floors, and currently have a wired LAN. They have contacted you to perform a WLAN site survey of their facility. Which three issues do you need to take into consideration before performing the site survey? (Choose three.)

  A. How many other organizations occupy the building?
  B. Does the customer facility have a multistory atrium or lobby?
  C. Protocol type required, client types in place, and client density?
  D. Is WLAN coverage required in the elevators?
  E. How many equipment closets do they have per floor and does the infrastructure all run back to a central location?
  F. How much signal bleedthrough is permissible between floors?
  G. How much WLAN experience does the customer IT staff have?
  B. Does the customer facility have a multistory atrium or lobby?
  C. Protocol type required, client types in place, and client density?
  D. Is WLAN coverage required in the elevators?