Cisco 400-051 Online Practice
Questions and Exam Preparation
400-051 Exam Details
Exam Code
:400-051
Exam Name
:CCIE Collaboration Written
Certification
:Cisco Certifications
Vendor
:Cisco
Total Questions
:585 Q&As
Last Updated
:Dec 15, 2021
Cisco 400-051 Online Questions &
Answers
Question 331:
Which two types of patterns are marked with urgent priority by default in Cisco Unified Communications Manager version 11.0? (Choose two.)
A. Route Pattern B. Confrence Now IVR Directory Number C. Voice Mail Port Directory Number D. Translation Pattern E. Remote Destination Directory Number F. Intercom Translation Pattern
A. Route Pattern D. Translation Pattern
Question 332:
A Cisco Unified CM cluster is being set up for call control discover using the service advertising framework. An engineer discovers that patterns are not being learned by the cluster. Which two items must be checked in an attempt to resolve the issue? (Choose two)
A. The CCD block patterns are not preventing remote patterns from being entered into the local cache. B. The hostedDN group on the cluster matches the patterns that should be learned. C. The CCD advertising service is activated in Cisco unified CM serviceability. D. A CCD route partition has been assigned for learned patterns. E. The CCD requesting service is activated in Cisco unified CM serviceability. F. The Sip trunk is enabled for call control discover.
A. The CCD block patterns are not preventing remote patterns from being entered into the local cache. F. The Sip trunk is enabled for call control discover.
Question 333:
Refer to the exhibit.
The MGCP debugs were captured on a Cisco IOS MGCP PRI gateway registered to a Cisco Unified CM. Assume that this gateway had no active calls and will not take any new calls for the next 3 minutes. What time it will send the next NTFY message to the Cisco Unified CM?
A. Jan 10 05:56:35.130 B. Jan 10 05:55:45.130 C. Jan 10 05:55:50.130 D. Jan 10 05:56:05.130 E. Jan 10 05:55:40.130
C. Jan 10 05:55:50.130
NTFY keepalive messages are sent every 15 seconds, even when no calls are active.
Question 334:
Refer to the exhibit.
A Cisco collaboration engineer has been asked to remove the ability HQ phone 2 to dial HQ phone 1 by URI dialing. After removing the partition assigned to [email protected] HQ phone 2's CSS, HQ phone 2 is still able to reach HQ phone 1. Why is the HQ phone 1 still reachable using URI dialing?
A. Directory URI Alias partition has been defined in Enterprise parameters. B. Phone needs to be reset for changes to take effect. C. Directory URI partition cannot be deleted therefore still will be reachable. D. CSS Changes failed to be applied after hitting save due to Database replication issues.
A. Directory URI Alias partition has been defined in Enterprise parameters.
Question 335:
Which call processing feature overrides the Do Not Disturb settings on a Cisco IP phone?
A. park reversion for remotely parked calls by a shared line B. hold reversion C. remotely placed pickup request by a shared line D. pickup notification E. terminating side of a call back
B. hold reversion
Hold Reversion and Intercom
Hold reversion and intercom override DND (both options), and the call gets presented normally.
Which two descriptions of TFTP option 66 and 150 for Cisco IP phones are true? (Choose two.)
A. Option 150 supports multiple entries of TFTP server IP addresses, but option 66 supports only one of TFTP server DNS names. B. Option 150 supports only TFTP server IP addresses, but option 66 supports only TFTP server DNS names. C. Option 150 supports multiple entries of TFTP server IP addresses, but option 66 supports only one entry of either TFTP server IP address or DNS name. D. Option 66 is Cisco proprietary, but option 150 is standard-based. E. Option 150 is Cisco proprietary, but option 66 is standard-based. F. Option 150 and 66 are standard-based.
C. Option 150 supports multiple entries of TFTP server IP addresses, but option 66 supports only one entry of either TFTP server IP address or DNS name. E. Option 150 is Cisco proprietary, but option 66 is standard-based.
Question 337:
Which option describes how you can show the same contacts in your Jabber for Windows on-premise client as you do on the corporate directory of your IP phone?
A. Switch your Jabber client to use UDS instead of EDI. B. Switch your Jabber client to use EDI instead of UDS. C. Update your IMandP server to sync off of the same LDAP directory as your Cisco Unified Communications Manager. D. Add Jabber to your inbound/outbound firewall rules on your PC. E. Jabber can only pull directly from LDAP and cannot directly search the Cisco Unified Communications Manager user database.
A. Switch your Jabber client to use UDS instead of EDI.
LDAP contact resolution -- The client cannot use LDAP for contact resolution when outside of the corporate firewall. Instead, the client must use UDS for contact resolution. When users are inside the corporate firewall, the client can use either UDS or LDAP for contact resolution. If you deploy LDAP within the corporate firewall, Cisco recommends that you synchronize your LDAP directory server with Cisco Unified Communications Manager to allow the client to connect with UDS when users are outside the corporate firewall.
Which DTMF relay method is advertised when the originating SIP gateway sends an INVITE message with a Call-Info header shown?
A. RFC 2833 B. SIP INFO C. SIP NOTIFY D. SIP KPML E. In-band audio
C. SIP NOTIFY
You can develop user-specific applications that reside on your network entity and have the ability to subscribe for event services supported by the IMG. If the network entity wants the ability to detect an entered DTMF digit (only telephone event of "###" are currently supported) from the TDM-side of a call to the IP side of a call, the entity can subscribe to the IMG for these events and receive SIP NOTIFY events containing the digit event.
Question 339:
Which parameter in an NTFY message is used by a Cisco IOS MGCP gateway to inform a Cisco Unified CM that an analog endpoint has gone off-hook?
A. Detect Events B. Event States C. Connection Mode D. Observed Events E. Requested Events
D. Observed Events
Question 340:
Which SIP request is used by a Cisco 9971 IP Phone to signal DND status changes to Cisco Unified Communications Manager?
A. REGISTER B. NOTIFY C. INFO D. PUBLISH E. UPDATE
D. PUBLISH
Cisco Unified Communications Manager supports Do Not Disturb that a SIP device initiates or that a Cisco Unified Communications Manager device initiates. A DND status change gets signaled from a SIP device to Cisco Unified Communications Manager by using the SIP PUBLISH method (RFC3909). A DND status change gets signaled from a Cisco Unified Communications Manager to a SIP device by using a dndupdate Remote-cc REFER request. Cisco Unified Communications Manager can also publish the Do Not Disturb status for a device, along with the busy and idle status for the device.
Nowadays, the certification exams become more and more important and required by more and more
enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare
for the exam in a short time with less efforts? How to get a ideal result and how to find the
most reliable resources? Here on Vcedump.com, you will find all the answers.
Vcedump.com provide not only Cisco exam questions,
answers and explanations but also complete assistance on your exam preparation and certification
application. If you are confused on your 400-051 exam preparations
and Cisco certification application, do not hesitate to visit our
Vcedump.com to find your solutions here.