Cisco 351-080 Online Practice Questions and Exam Preparation

Cisco 351-080 Online Questions & Answers

• Question 371:

  Refer to the exhibit.

  

  Given the displays from N5K-1 and N5K-2, what is the expected result if the zone mode enhanced vsan 1 command is issued on N5K-1?

  A. The mode change will complete with a warning that the zone database from N5K-1 will be distributed throughout the fabric.
  B. The mode change will not complete due to the mismatch in the default zone mode.
  C. The mode change prompts the administrator to override the default zone mismatch and make them the same.
  D. The mode change completes, and the default zone setting remains unchanged in N5K-1 and N5K-2.
  E. The default zone setting is set to deny in both switches because it is more secure.
  A. The mode change will complete with a warning that the zone database from N5K-1 will be distributed throughout the fabric.

• Question 372:

  Drag and drop the DIMM bank color on the left in the correct order of population for a B230 server on the right.

  Select and Place:

  

  

• Question 373:

  Refer to the exhibit.

  

  The following message output was displayed while configuring PIM on Nexus 7000. Which command should be configured on the Cisco Nexus 7000 Series switch to allow the desired configuration?

  A. feature multicast
  B. feature pim
  C. ip multicast-routing
  D. ip pim routing
  B. feature pim

• Question 374:

  Which three statements about FabricPath are true? (Choose three.)

  A. Only FabricPath VLANs can cross a FabricPath domain.
  B. A vPC+ peer link can be formed out of F1 or F2 ports only.
  C. With FabricPath, vPC must be changed to vPC+.
  D. F1 ports must be placed into a separate VDCs.
  E. A vPC+ peer link can be formed out of F2 ports only.
  A. Only FabricPath VLANs can cross a FabricPath domain.
  B. A vPC+ peer link can be formed out of F1 or F2 ports only.
  C. With FabricPath, vPC must be changed to vPC+.

• Question 375:

  Which trancseiver allows 40 GB Ethernet Connectivity by leveraging a single pair of multimode fibers?

  A. OSFP-40G-SR4
  B. OSFP-H40G-CU
  C. FET-40G
  D. QSFP-40G-SR-BD
  D. QSFP-40G-SR-BD

• Question 376:

  Which statement is true about The QoS Class Fibre Channel?

  A. Cannot be disabled
  B. Cannot have the QoS changed
  C. Can have "Packet Drop" enabled
  D. Is multicast optimized?
  E. Can have the MTU changed
  A. Cannot be disabled

• Question 377:

  OTV is a MAC-in-IP method that extends Layer 2 connectivity across a transport network infrastructure. Which three options are high-availability features? (Choose three.)

  A. OTV fast convergence
  B. fast failure detection
  C. added the track-adjacency-nexthop command to enable overlay route tracking
  D. added support for unicast cores using an adjacency server
  E. added support for Ipv6 unicast forwarding and multicast flooding across the OTV overlay
  A. OTV fast convergence
  B. fast failure detection
  E. added support for Ipv6 unicast forwarding and multicast flooding across the OTV overlay

• Question 378:

  Which statement describes the below output from an MDS switch? Flow ID. 44 Initiator VSAN: 200 Initiator WWN: 50:06:04:8a: cc: 19:12: db Target VSAN: 200 Target WWN: 50:06:04:8c: de: ad: be: ef

  Target LUN: ALL LUNs Acceleration enabled Write-Acceleration Buffers: 1024 Configuration Status: flow verification failed

  

  A. The zone containing both the initiator and target does not exist
  B. The zone set has not been activated
  C. The target is not logged into the fabric
  D. The pWWN used for the target is invalid
  C. The target is not logged into the fabric

• Question 379:

  The Cisco Nexus 1000v Series switches can configure traditional SPAN sessions. Which three statements about the local SPAN source ports are true? (Choose three.)

  A. It can be configured to monitor the direction of the traffic.
  B. It must be in the same VSAN.
  C. It can be port type Ethernet, virtual Ethernet, or port channel.
  D. It must be in the same VLAN.
  E. It cannot be on a different host VEM as the destination port.
  F. It cannot be a port profile.
  A. It can be configured to monitor the direction of the traffic.
  C. It can be port type Ethernet, virtual Ethernet, or port channel.
  E. It cannot be on a different host VEM as the destination port.

• Question 380:

  How are IP multicast IGMP entries synchronized between vPC peers?

  A. IGMP is not synchronized between vPC peers
  B. Cisco Fabric Service carries IGMP entries across the vPC peer link C. IP ARP synchronization under the vPC domain configuration also synchronizes IGMP
  D. IGMP is flooded to the L2 domain, and there is no need to synchronize it between vPC peers
  B. Cisco Fabric Service carries IGMP entries across the vPC peer link C. IP ARP synchronization under the vPC domain configuration also synchronizes IGMP