Cisco 350-050 Online Practice Questions and Exam Preparation

Cisco 350-050 Online Questions & Answers

• Question 181:

  You calculate that your AP should transmit at 6 dBm to provide appropriate wireless coverage, while still complying with EIRP, with the antennas that you selected. However, the AP is transmitting at 1 dBm only, even though it is on power level 1. How can you increase the transmitting power?

  A. Choose appropriate antennas types.
  B. Decrease the antenna gain that is configured on the Cisco WLC.
  C. Switch to a custom Tx power level and increase the power level.
  D. Disable auto-RF.
  E. Activate 802.11n legacy beamforming on the Cisco WLC.
  B. Decrease the antenna gain that is configured on the Cisco WLC.

• Question 182:

  Which WLC feature allows an administrator to limit a wireless client to trigger a change in the AP power settings?

  A. Wireless Protection Policies
  B. Management Frame Protection
  C. Cisco Aironet Extensions
  D. Coverage Hole Detection
  E. Transmit Power Control
  D. Coverage Hole Detection

• Question 183:

  The IT manager wants the Cisco WCS to send email notifications of alarms to identify issues in a timely fashion. The manager finds that not all of the alarms were sent via email. Which default severity level of alarm will trigger an email?

  A. major
  B. critical
  C. minor
  D. informational
  E. critical and major
  B. critical

• Question 184:

  Refer to the exhibit.

  

  What can be filtered by using this DNIS filter on ACS?

  A. wireless clients, based on the SSID to which they are associating
  B. wireless IP phones, based on the phone number that they are calling
  C. authentications from AAA clients, based on their assigned location
  D. authentications from a specific Cisco WLC interface
  E. authentications, based on part of the username
  A. wireless clients, based on the SSID to which they are associating

• Question 185:

  Refer to the exhibit.

  

  Which DHCP option is shown?

  A. Option 60
  B. Option 241
  C. Option 32
  D. Option 150
  E. Option 43
  E. Option 43

• Question 186:

  When deploying the Cisco Unified Wireless IP Phone 7925 running firmware release 1.3.4 on a Cisco Unified architecture, which features should you enable to support fast secure roaming while maintaining a scalable deployment?

  A. The controller supports PKC, so use WPA2 802.1X.
  B. The controller does not support PKC, so use WPA2 PSK.
  C. The controller does not support OKC, so use WPA2 PSK.
  D. The 7925 does not support WPA2 with Cisco CKM, so use WPA2 PSK.
  E. The 7925 supports WPA2 with Cisco CKM, so use WPA2 802.1X.
  F. The 7925 supports PKC, so use WPA2 802.1X.
  E. The 7925 supports WPA2 with Cisco CKM, so use WPA2 802.1X.

• Question 187:

  Which of the below devices can cause unintentional RF jamming attacks against an 802.11 wireless network? (Choose two.)

  A. Rogue Access Points
  B. Microwave Oven
  C. Radar
  D. 900 Mhz cordless phones
  B. Microwave Oven
  C. Radar

• Question 188:

  Which RRM feature increases the AP radio Tx power when the client SNR levels pass below a given threshold?

  A. Dynamic Channel Assignment
  B. Transmit Power Control
  C. Dynamic Transmit Power Control
  D. Coverage Hole Detection
  D. Coverage Hole Detection

• Question 189:

  A router has two interfaces: Ethernet 0 is connected to the LAN and Ethernet 1 is connected to the Internet. The LAN is 20.20.20.0/24. All hosts on the LAN must be able to form TCP connections to any host on the Internet. Hosts on the Internet may not form TCP connections to hosts on the LAN, except to port 25 of a mail server on the LAN. The web server IP address is 20.20.20.100. Which configuration fulfills all the requirements?

  A. interface ethernet 1 ip access-group 123 in ! access-list 123 permit tcp any 20.20.20.0 0.0.0.255 access-list 123 permit tcp any host 20.20.20.100 eq 25
  B. interface ethernet 1 ip access-group 123 in ! access-list 123 permit tcp any 20.20.20.0 0.0.0.255 established access-list 123 permit tcp any host 20.20.20.100 eq 25
  C. interface ethernet 1 ip access-group 123 in ! access-list 123 permit tcp any host 20.20.20.100 eq 25 access-list 123 deny tcp any 20.20.20.0 0.0.0.255
  D. interface ethernet 1 ip access-group 123 in ! access-list 123 deny tcp any 20.20.20.0 0.0.0.255 access-list 123 permit tcp any host 20.20.20.100 eq 25
  E. interface ethernet 1 ip access-group 123 in ! access-list 123 permit tcp any host 20.20.20.100 eq 25 access-list 123 permit tcp 20.20.20.0 0.0.0.255 any access-list 123 deny tcp any 20.20.20.0 0.0.0.255
  B. interface ethernet 1 ip access-group 123 in ! access-list 123 permit tcp any 20.20.20.0 0.0.0.255 established access-list 123 permit tcp any host 20.20.20.100 eq 25

• Question 190:

  You are configuring a RADIUS server and the security team asks you for details about this protocol. Which three statements about the RADIUS protocol are true? (Choose three.)

  A. It is TCP based.
  B. It is UDP based.
  C. RADIUS servers use port 1645 or port 1812 for authentication.
  D. RADIUS servers use port 1646 or port 1813 for authorization.
  E. The username is sent in cleartext.
  F. The username is encrypted.
  B. It is UDP based.
  C. RADIUS servers use port 1645 or port 1812 for authentication.
  E. The username is sent in cleartext.