F5 303 Online Practice Questions and Exam Preparation

F5 303 Online Questions & Answers

• Question 271:

  An LTM Specialist needs to configure asetup for antivirus scanning of HTTP traffic with an internet Contact adaption Protocol (ICAP) server. Which two server type should be used? (Choose two.)

  A. Standard
  B. Internal
  C. Performance HTTP
  D. Forwarding IP
  E. Stateless
  A. Standard
  B. Internal

• Question 272:

  A BIG-IP Administrator opens a case with F5 Support. The support engineer requests the BIG-IP appliance chassis serial number. Which TMSH command will provide this information?

  A. . list /sys software
  B. show /sys version
  C. list/sys diags
  D. show /sys hardware
  D. show /sys hardware

• Question 273:

  A OneConnect profile is applied to a virtual server. The LTM Specialist would like the client source IP addresses within the 10.10.10.0/25 range to reuse an existing server side connection. Which OneConnect profile source mask should the LTM Specialist use?

  A. 0.0.0.0
  B. 255.255.255.0
  C. 255.255.255.128
  D. 255.255.255.224
  E. 255.255.255.255
  C. 255.255.255.128

• Question 274:

  Refer to the exhibit.

  

  Based on the output of the tmsh interface show command, what is the issue?

  A. There is a duplex mismatch on the management interface.
  B. Interfaces 2.1 and 2.2 are defective and need replacement.
  C. Flow Control is NOT configured on the management interface.
  D. There are too many drops on inbound traffic on interface 1.1.
  A. There is a duplex mismatch on the management interface.

• Question 275:

  A BIG-IP Administrator applied the latest hotfix to an inactive boot location by mistake, and needs to downgrade back to the previous hotfix. What should the BIG-IP Administrator do to change the boot location to the previous hotfix?

  A. Uninstall the newest hotfix and reinstall the previous hotfix
  B. Reinstall the base version and install the previous hotfix
  C. Reinstall the previous hotfix and re-activate the license
  D. Uninstall the base version and restore the UCS
  B. Reinstall the base version and install the previous hotfix

• Question 276:

  A BIG-IP Administrator is performing maintenance on the active BIG-IP device of an HA pair. The BIG-IP Administrator needs to minimize traffic disruptions. What should the BIG-IP Administrator do to start the maintenance activity?

  A. Reboot the BIG-IP device.
  B. Move resources to a new Traffic Group.
  C. Force the BIG-IP device to standby.
  D. Disable switch ports of the BIG-IP device.
  C. Force the BIG-IP device to standby.

• Question 277:

  A pool of four servers has been partially upgraded for two new servers with more memory and CPU capacity. The BIG-IP Administrator must change the load balance method to consider more connections for the two new servers. Which load balancing method considers pool member CPU and memory load?

  A. Round Robin
  B. Dynamic Ratio
  C. Ratio
  D. Least Connection
  C. Ratio

• Question 278:

  Refer to the exhibit.

  

  An LTM Specialist is troubleshooting an issue with a new virtual server. When connecting through the virtual server, clients receive the message "The connection was reset" in the browser.

  Connections directly to the pool member show the application is functioning correctly.

  What is the issue?

  A. The pool member is failing the monitor check.
  B. The pool member default gateway is set incorrectly.
  C. The virtual server is configured with the incorrect SNAT address.
  D. The virtual server is processing encrypted traffic as plain-text HTTP.
  D. The virtual server is processing encrypted traffic as plain-text HTTP.

• Question 279:

  AN LIM Specialist must upgrade the VCMP Guest active/standby LTM pair from version 11.3 to 11.5.3 on two VCMP Hosts. Where should the LTM Specialist import the latest 11.5.3 ISO images?

  A. to the primary VCMP Host and the active Guest instance
  B. to both VCMP Hosts
  C. to the secondary vCMP Host and the standby Guest instance
  D. to the VCMP Guest instances
  D. to the VCMP Guest instances

• Question 280:

  Internet clients connecting to a virtual server to download a file are experiencing about 150 ms of latency and no packet loss. Which built-in client-side TCP profile provides the highest throughput?

  A. tcp
  B. tcp-legacy
  C. tcp-lan-optimized
  D. tcp-wan-optimized
  D. tcp-wan-optimized