Cisco 300-115 Online Practice Questions and Exam Preparation

Cisco 300-115 Online Questions & Answers

• Question 1001:

  Under which two conditions does Cisco StackWise Virtual transmit data over a virtual link? (Choose two.)

  A. Packets are processed on the ingress interface on the active switch.
  B. A VLAN is flooded over Layer 2.
  C. Packets are processed on the ingress interface on the standby switch.
  D. Packets are processed on the egress interface on the active switch.
  E. Packets are processed on the egress interface on the standby switch.
  B. A VLAN is flooded over Layer 2.
  C. Packets are processed on the ingress interface on the standby switch.

• Question 1002:

  Which three authentication messages does RADIUS use? (Choose three.)

  A. Access-Accept
  B. Access-Reject
  C. Access-Challenge
  D. Access-Encryption
  E. Access-Protected
  A. Access-Accept
  B. Access-Reject
  C. Access-Challenge

• Question 1003:

  Why the network administration can want to to disable MAC address learning on the router?

  A. To free up space in MAC address table.
  B. To use space in MAC address table
  C. To wipe space in MAC address table.
  D. There was a security violation.
  A. To free up space in MAC address table.

• Question 1004:

  Which statement is true when one of its virtual gateway redundancy with an AVF has failed?

  A. If an AVF has failed, one of the primary virtual forwarders in the listen state assumes responsibility for the virtual MAC address.
  B. If an AVF has failed, one of the secondary virtual forwarders in the listen state assumes responsibility for the virtual MAC address.
  C. If an AVF has failed, one of the secondary virtual forwarders in the listen state will also fail.
  D. If an AVF has failed, one of the primary virtual forwarders in the listen state will also fail.
  B. If an AVF has failed, one of the secondary virtual forwarders in the listen state assumes responsibility for the virtual MAC address.

• Question 1005:

  Which type of failure has occurred, if a link fails and the MEC successfully redistributes the load among the remaining operational links?

  A. multiple MEC link failure
  B. standby switch failure
  C. active switch failure
  D. single MEC link failure
  D. single MEC link failure

• Question 1006:

  When Ether Channel guard is enabled and a misconfiguration is detected on a port, how does the port respond"?

  A. It enters the channel-error state
  B. enters the errdisable state
  C. The port remains up. but it is unable to pass traffic
  D. enters the shutdown state
  E. The port state remains unchanged, but the EtherChannel stays down.
  A. It enters the channel-error state

• Question 1007:

  

  Refer to the exhibit.Which two statements can be derived from the output of the show standby command ?Choose two

  A. R2 Fa1/0 regains mastership when the link comes back up
  B. R2 becomes the active router after the hold time expires
  C. if Fa0/0 is shut down,the HSRP priority on R2 becomes 80
  D. R2 is using the default HSRP hello and hold timers
  C. if Fa0/0 is shut down,the HSRP priority on R2 becomes 80
  D. R2 is using the default HSRP hello and hold timers

• Question 1008:

  Which two configurations cause the frames to be tagged? (Choose two.)

  A. interface gi 0/1.116 encapsulation dot1q
  B. trunk allowed vlan 116
  C. interface with access and voice VLAN configured to 116
  D. interface encapsulation native vlan
  E. switchport mode on
  A. interface gi 0/1.116 encapsulation dot1q
  B. trunk allowed vlan 116

• Question 1009:

  It a switch stack is configured to used SDM templates, where are the templates stored?

  A. stack master
  B. TFTP server
  C. flash memory
  D. all stack members
  A. stack master

• Question 1010:

  Refer to the exhibit.

  monitor session 1 source vlan 10-12 rx monitor session 1 destination interface gigabitethernet0/1

  Which effect of this configuration is true?

  A. Traffic sent on VLANs 10, 11, and 12 is copied and sent to interface g0/1.
  B. Traffic received on VLANs 10, 11, and 12 is copied and sent to interface g0/1.
  C. Traffic sent on VLANs 10 and 12 only is copied and sent to interface g0/1.
  D. Traffic received on VLANs 10 and 12 only is copied and sent to interface g0/1.
  D. Traffic received on VLANs 10 and 12 only is copied and sent to interface g0/1.