Cisco 300-080 Online Practice Questions and Exam Preparation

Cisco 300-080 Online Questions & Answers

• Question 261:

  Refer to the exhibit. Assuming that the two Cisco SAF Forwarders are adjacent to each other and that no SAF clients have been configured, which statement is true?

  

  A. The Cisco SAF Forwarders will not establish a neighbor relationship because the service-family external-client configuration is missing.
  B. The Cisco SAF Forwarders will not establish a neighbor relationship because the eigrp label CUCME should be replaced with SAF.
  C. The Cisco SAF Forwarders will not establish a neighbor relationship because the service-family external-client configuration is missing as well as the static neighbor configurations.
  D. The Cisco SAF Forwarders will establish a neighbor relationship. No further configuration is required.
  E. Cisco SAF Forwarders will not establish a neighbor relationship until the SAF clients are configured and registered to the Cisco SAF Forwarders.
  D. The Cisco SAF Forwarders will establish a neighbor relationship. No further configuration is required.

• Question 262:

  Which Cisco TelePresence Management Suite feature provides proactive suggestions for resolving error conditions and also provides a centralized view of all statuses and configuration errors for managed devices?

  A. Cisco WebEx in Cisco TelePresence Management Suite
  B. Cisco TelePresence scheduling
  C. graphical monitoring
  D. ticketing service
  E. audit logging
  D. ticketing service

• Question 263:

  Cisco Unified Communications Manager failed to register with the Cisco SAF Forwarder. Assuming that the Cisco IOS SAF Forwarder is configured correctly, which minimum configuration would be needed on Cisco Unified Communications Manager to test registration?

  A. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD advertising service
  B. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD requesting service
  C. SAF trunk, SAF security profile, Cisco SAF Forwarder, CCD requesting service, and CCD advertising service
  D. SAF trunk, SAF security profile, and Cisco SAF Forwarder
  E. SAF trunk, CCD requesting service, and CCD advertising service
  B. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD requesting service

• Question 264:

  In a single-site deployment model, the internal endpoints are unable to dial from one to the other. What are two possible causes? (Choose two.)

  A. The PSTN gateway is not configured.
  B. The called endpoint does not have the SIP trunk enabled.
  C. The called endpoint is not registered.
  D. The calling endpoint is not in the CSS of the called endpoint.
  E. The called endpoint is not in the partition of the calling endpoint.
  F. The calling endpoint is not configured for the correct CoS.
  C. The called endpoint is not registered.
  F. The calling endpoint is not configured for the correct CoS.

• Question 265:

  In a SIP direct call setup, the originating UAC sends what message to the UAS of the recipient?

  A. INVITE
  B. RINGING
  C. ACK
  D. OK
  A. INVITE

• Question 266:

  Refer to the exhibit. When the user tried to configure the command maximum sessions 5 under the dspfarm profile 1, the error shown in the exhibit was reported. Which course of action will resolve this issue?

  

  A. The maximum conference-participants value must be configured >0.
  B. Ensure that the conference bridge is not registered in Cisco Unified Communications Manager.
  C. The command dsp services dspfarm must be configured under the voice-card configuration.
  D. Configure the dspfarm all command under the voice card.
  C. The command dsp services dspfarm must be configured under the voice-card configuration.

• Question 267:

  Refer to the exhibits. Assume that all learned SAF routes are placed in the SAF_Pt partition. An IP phone CSS contains the following partitions in this order: Internal_Pt, SAF_Pt. When the IP phone places a call to 3001, what will occur?

  

  A. The call will succeed and will be placed via the SAF network. SAF-learned routes always take precedence.
  B. The call will fail because it will be blocked by the route pattern.
  C. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk.
  D. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk. Every other call will fail.
  B. The call will fail because it will be blocked by the route pattern.

• Question 268:

  You are troubleshooting media issues during SIP calls on a C-series collaboration endpoint that is running TC6.3 software.

  You are asked to recreate the problem and to provide a packet capture from the endpoint.

  Which four of the following are required to accurately perform a packet capture on a C-series endpoint? (Choose four.)

  A. Set up administrator access on the endpoint.
  B. Set up root access on the endpoint.
  C. Start the call, and then enter the tcpdump command string to begin the capture.
  D. On the endpoint, set the default transport to TLS.
  E. Set the default transport to TCP.
  F. Stop the capture by pressing the key combination Ctrl + C.
  G. Start the capture by entering the tcpdump command string and then start the call.
  B. Set up root access on the endpoint.
  E. Set the default transport to TCP.
  F. Stop the capture by pressing the key combination Ctrl + C.
  G. Start the capture by entering the tcpdump command string and then start the call.

• Question 269:

  You must integrate a third-party H.323 system with your existing Cisco Unified Communications Manager cluster. When you create an H.323 trunk from the cluster, calls from the cluster to the third- party H.323 system are failing. The vendor

  of the third-party H.323 device has confirmed that the H.323 call setup time must be reduced.

  Which two approaches reduce the call setup time from Cisco Unified Communications Manager to the third-party H.323 device? (Choose two.)

  A. Implement a software MTP.
  B. Implement a hardware MTP.
  C. Implement transcoding with the router DSP resources.
  D. Implement transcoding with the Cisco Unified Communications Manager resources.
  A. Implement a software MTP.
  B. Implement a hardware MTP.

• Question 270:

  Which statement indicates something that can cause an inbound PSTN call to an H.323 gateway that is configured in Cisco Unified Communications Manager to fail to ring an IP phone?

  A. The gateway is not registered in Cisco Unified Communications Manager.
  B. The gateway IP address that is configured in Cisco Unified Communications Manager does not match the IP address that is configured at the gateway in the h323-gateway voip bind srcaddr command.
  C. The Cisco Unified Communications Manager does not have a matching route pattern to match the called number.
  D. The gateway is missing the command allow-connections h323 to h323 under the voice service voip configuration.
  B. The gateway IP address that is configured in Cisco Unified Communications Manager does not match the IP address that is configured at the gateway in the h323-gateway voip bind srcaddr command.