Cisco 200-355 Online Practice Questions and Exam Preparation

Cisco 200-355 Online Questions & Answers

• Question 281:

  In what WCS menu would an engineer locate the WCS software version?

  A. Administration > Settings
  B. Help > About Cisco WCS
  C. Help > Online Help
  D. Administration > License Center
  B. Help > About Cisco WCS

• Question 282:

  Wireless clients are experiencing loss of connectivity while roaming between controllers. To fix this, what configuration should be the same on all controllers within the mobility group?

  A. management interface IP address
  B. IP address of the virtual interface
  C. AP Manager interface IP address
  D. IP address of the Service Port
  B. IP address of the virtual interface

• Question 283:

  Refer to the exhibit.

  

  At which point in the network topology must the trunk be configured to support multiple SSIDs for voice and data separation?

  A. A
  B. B
  C. C
  D. D
  D. D

  ---

  Controllers typically map WLANs to VLANs. When configuring a switch port to a controller, you would set the port to support 802.1Q (switchport trunk encapsulation dot1q), then set the port to trunk (switchport mode trunk) and only allow the VLANs needed by the controller (for example, switchport trunk allowed VLANs 10,20,30 if your controller needs only VLANs 10, 20, and 30).

• Question 284:

  Which statement correctly describes the procedure for a lightweight AP to successfully establish a connection to a controller?

  A. The AP authenticates the received Cisco WLC certificate as valid. The AP then sends its certificate to the controller.
  B. The AP sends its certificate to the controller. The AP then authenticates the received Cisco WLC certificate as valid.
  C. The AP sends its certificate to the RADIUS server. The AP then authenticates the controller certificate as valid.
  D. The AP sends its certificate to the RADIUS server. The AP then authenticates the RADIUS certificate as valid.
  E. The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the RADIUS server.
  F. The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the controller.
  B. The AP sends its certificate to the controller. The AP then authenticates the received Cisco WLC certificate as valid.

  ---

  The controller will respond to all discovery requests without checking certificates or AP credentials. However, join requests must have a valid certificate in order to get a join response from the controller. If the LAP does not receive a join response from its choice, the LAP will try the next controller in the list unless the controller is a configured controller (Primary/Secondary/Tertiary). http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lancontrollers/99948-lap-notjoin-wlc-tshoot.html#backinfo

• Question 285:

  What is Cisco WCS Navigator?

  A. a single point of management for multiple Cisco WCS servers
  B. a server for storing and reviewing Cisco Spectrum Expert station data
  C. a server for storing the location data of wireless clients
  D. a GUI for displaying the data of Cisco CleanAir APs, aligned with an uploaded map
  E. a single point of management for multiple Cisco WLC systems
  A. a single point of management for multiple Cisco WCS servers

  ---

  The Cisco WCS Navigator centralizes the operational control and management of multiple Cisco WCS management platforms. This easy-to-use platform delivers the following cross-system capabilities: http://www.cisco.com/c/en/us/products/wireless/wireless-control-system-navigator/index.html

• Question 286:

  When Cisco AnyConnect modules are installed on a PC, which module must be installed first?

  A. telemetry
  B. web security
  C. VPN
  D. NAM
  E. DART
  F. posture
  G. CSSC
  C. VPN

  ---

  The VPN module is mandatory for all other modules to function correctly and must be installed first. Even if the VPN module is not selected for installation, it will be pushed and installed on the client. http://www.cisco.com/c/en/us/support/docs/security/anyconnect-secure-mobility-client/118714-configure-ise-00.html

• Question 287:

  Which two states are valid when an AP discovers and joins a controller? (Choose two.)

  A. connected
  B. discovery mode
  C. image data
  D. discoverable
  E. authentication request
  B. discovery mode
  C. image data

• Question 288:

  Which operating mode is valid for controllers in a converged access architecture?

  A. switch peer groups
  B. mobility controller
  C. auto-anchor
  D. foreign anchor
  B. mobility controller

• Question 289:

  In version 8.0 code for CUWN, what interface can be assigned an IPv6 address?

  A. management
  B. dynamic
  C. AP-manager
  D. virtual
  E. service-port
  A. management

• Question 290:

  When roaming between APs in an ESS, which value changes?

  A. BSSID
  B. SSID
  C. VLAN
  D. IP range
  A. BSSID