Cisco 200-150 Online Practice Questions and Exam Preparation

Cisco 200-150 Online Questions & Answers

• Question 191:

  A SAN administrator recently added a new zone to the VSAN 2 zone set named zone set2, but the server is still unable to access the shared storage.

  Which command will resolve this issue?

  A. zone copy active-zoneset ful-zoneset
  B. zoneset activate zoneset 2
  C. zone default-zone permit vsan 2
  D. copy running onfig startup-config
  B. zoneset activate zoneset 2

• Question 192:

  What two actions can be taken to enable inter-VLAN communications in the data center? (Choose two.)

  A. extend Layer 2 services to a Layer 3 capable VLAN using Layer 3 tunneling.
  B. use a routing protocol to direct packets into the Layer 2 network
  C. connect Layer 2 VLANs together with 802.1Q trunks
  D. deploy a router as a Layer 3 services gateway attached inside each Layer 2 VLAN
  E. install a Layer 3 capable switch in the data center.
  D. deploy a router as a Layer 3 services gateway attached inside each Layer 2 VLAN
  E. install a Layer 3 capable switch in the data center.

• Question 193:

  In an IEEE 802.3 Ethernet frame, what is the significance of the DSAP field?

  A. The DSAP field specifies the TCP or UDP port that is associated with the transport protocol.
  B. The DSAP field is only used on United States Department of Defense networks to indicate the information classification level.
  C. The DSAP field is only used in Ethernet II frames.
  D. The DSAP field indicates the network layer protocol.
  D. The DSAP field indicates the network layer protocol.

• Question 194:

  What protocol is used by TMS when a system cannot be contacted using SNMP?

  A. H.245
  B. https
  C. H 239
  D. TIP
  B. https

• Question 195:

  Which two protocols operate at the data link layer of the OSI reference model? (Choose two.)

  A. STP
  B. NetBIOS
  C. OSPF
  D. ICMP
  E. LLDP
  A. STP
  E. LLDP

• Question 196:

  Refer to the exhibit.

  

  Regarding the OSI networking model and the updated TCP/IP networking model, which statement about this scenario is true?

  A. Model A is TCP/IP, Model B is OSI, Layer C is Transport, Layer D is Internet, and Layer E is Physical.
  B. Model A is OSI, Model B is TCP/IP, Layer C is Session, Layer D is Network, and Layer E is Physical.
  C. Model A is OSI, Model B is TCP/IP, Layer C is Transport, Layer D is Data Link, and Layer E is Physical.
  D. Model A is TCP/IP, Model B is OSI, Layer C is Transport, Layer D is Internet, and Layer E is Network Access.
  C. Model A is OSI, Model B is TCP/IP, Layer C is Transport, Layer D is Data Link, and Layer E is Physical.

• Question 197:

  Refer to the exhibit. Which result of the command is true?

  

  A. All broadcast traffic is suppressed on Ethernet 1/1.
  B. All broadcast and multicast traffic is allowed on Ethernet 1/1.
  C. All broadcast traffic is allowed on Ethernet 1/1.
  D. All broadcast and multicast traffic is suppressed on Ethernet E1/1.
  B. All broadcast and multicast traffic is allowed on Ethernet 1/1.

• Question 198:

  What native Fibre Channel technology facilitates connecting multiple Fibre devices behind a single FC address?

  A. Fiber Channel over Ethernet
  B. N-Port Virtualization
  C. Fibre Channel Arbitrated Loop
  D. N-Port Identification Virtualization
  C. Fibre Channel Arbitrated Loop

• Question 199:

  What two technologies can be used to connect to storage arrays on a converged Ethernet IP network? (Choose two.)

  A. FCoE
  B. Fiber Channel
  C. iSCSI
  D. InfinBand
  E. FabricPath
  A. FCoE
  C. iSCSI

• Question 200:

  Which types of cable do you use to connect two Cisco switches that are 50 km apart?

  A. UTP
  B. STP
  C. MMF
  D. SMF
  D. SMF