Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 811:

  If router R1 knows a static route to a destination network and then learn about the same destination network through a dynamic routing protocol, how does R1 respond?

  A. It sends a withdrawal notification to the neighboring router.
  B. It refuses to advertise the dynamic route to other neighbors.
  C. It disables the routing protocol.
  D. It prefers the static route.
  D. It prefers the static route.

• Question 812:

  What are two reasons that duplex mismatches can be difficult to diagnose? (Choose two.)

  A. The interface displays a connected (up/up) state even when the duplex settings are mismatched.
  B. The symptoms of a duplex mismatch may be intermittent.
  C. Autonegotiation is disabled.
  D. Full-duplex interfaces use CSMA/CD logic, so mismatches may be disguised by collisions.
  E. 1-Gbps interfaces are full-duplex by default.
  A. The interface displays a connected (up/up) state even when the duplex settings are mismatched.
  B. The symptoms of a duplex mismatch may be intermittent.

• Question 813:

  When enabled, which feature prevents routing protocols from sending hello messages on an interface'?

  A. virtual links
  B. passive-interface
  C. directed neighbors
  D. OSPF areas
  B. passive-interface

  ---

  You can use the passive-interface command in order to control the advertisement of routing information. The command enables the suppression of routing updates over some interfaces while it allows updates to be exchanged normally over other interfaces. With most routing protocols, the passive-interface command restricts outgoing advertisements only. But, when used with Enhanced Interior Gateway Routing Protocol (EIGRP), the effect is slightly different. This document demonstrates that use of the passive-interface command in EIGRP suppresses the exchange of hello packets between two routers, which results in the loss of their neighbor relationship. This stops not only routing updates from being advertised, but it also suppresses incoming routing updates. This document also discusses the configuration required in order to allow the suppression of outgoing routing updates, while it also allows incoming routing updates to be learned normally from the neighbor.

• Question 814:

  Which IPv6 address is the all-router multicast group?

  A. FF02::1
  B. FF02::2
  C. FF02::3
  D. FF02::4
  B. FF02::2

  ---

  Well-known IPv6 multicast addresses: Address Description ff02::1 All nodes on the local network segment ff02::2 All routers on the local network segment

• Question 815:

  Which two statements about using leased lines for your WAN infrastructure are true? (Choose two.)

  A. Leased lines provide inexpensive WAN access.
  B. Leased lines with sufficient bandwidth can avoid latency between endpoints.
  C. Leased lines require little installation and maintenance expertise.
  D. Leased lines provide highly flexible bandwidth scaling.
  E. Multiple leased lines can share a router interface.
  F. Leased lines support up to T1 link speeds.
  B. Leased lines with sufficient bandwidth can avoid latency between endpoints.
  C. Leased lines require little installation and maintenance expertise.

• Question 816:

  Which functionality does an SVI provide?

  A. OSI Layer 2 connectivity to switches
  B. remote switch administration
  C. traffic routing for VLANs
  D. OSI Layer 3 connectivity to switches
  C. traffic routing for VLANs

• Question 817:

  Which two addresses are defined as private IP addresses? (Choose two)

  A. 172.31.255.100
  B. 12.17.1.20
  C. 172.15.2.250
  D. 10.172.76.200
  E. 192.109.32.10
  A. 172.31.255.100
  D. 10.172.76.200

• Question 818:

  Which two commands can be used to verify a trunk link configurationt status on a given cisco switch? (Choose two)

  A. show interfaces interface
  B. show interfaces trunk
  C. show interfaces switchport
  D. show ip interface brief
  E. show interfaces vlan
  B. show interfaces trunk
  C. show interfaces switchport

• Question 819:

  Drag and drop the CSMA components from the left onto the correct descriptions on the right.

  Select and Place:

  

  

• Question 820:

  In which STP state does MAC address learning take place on a PortFast-enabled port?

  A. listening
  B. forwarding
  C. discarding
  D. learning
  B. forwarding