Cisco 200-105 Online Practice Questions and Exam Preparation

Cisco 200-105 Online Questions & Answers

• Question 101:

  Which three options are the HSRP states for a router? (Choose three.)

  A. initialize
  B. learn
  C. secondary
  D. listen
  E. speak
  F. primary
  B. learn
  D. listen
  E. speak

  ---

  HSRP States

  

• Question 102:

  Which two pieces of information can be reported by an IP SLA? (Choose two.)

  A. delay
  B. reachability
  C. connected devices
  D. Cisco IOS version
  E. serial number
  A. delay
  B. reachability

• Question 103:

  DRAG DROP

  Drag and drop the descriptions of ACLs from the left onto the correct ACL types on the right.

  Select and Place:

  

  

• Question 104:

  Which WAN topology provides a direct connection from each site to all other sites on the network?

  A. single-homed
  B. full mesh
  C. point-to-point
  D. hub-and-spoke
  B. full mesh

• Question 105:

  Which statement about access lists that are applied to an interface is true?

  A. You can place as many access lists as you want on any interface.
  B. You can apply only one access list on any interface.
  C. You can configure one access list, per direction, per Layer 3 protocol.
  D. You can apply multiple access lists with the same protocol or in different directions.
  C. You can configure one access list, per direction, per Layer 3 protocol.

• Question 106:

  To which two categories of routing protocols does BGP belong? (Choose two.)

  A. link-state
  B. distance-vector
  C. path-vector
  D. composite
  E. exterior
  C. path-vector
  E. exterior

• Question 107:

  Refer to the exhibit. A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN 2. What causes this behavior?

  

  A. trunk mode mismatches
  B. allowing only VLAN 2 on the destination
  C. native VLAN mismatches
  D. VLANs that do not correspond to a unique IP subnet
  C. native VLAN mismatches

• Question 108:

  DRAG DROP

  Drag and drop the components of an inter-switch connection from the left onto the correct descriptions in the right.

  Select and Place:

  

  

• Question 109:

  Which command enables RSTP on a switch?

  A. spanning-tree mode rapid-pvst
  B. spanning-tree uplinkfast
  C. spanning-tree backbonefast
  D. spanning-tree mode mst
  A. spanning-tree mode rapid-pvst

• Question 110:

  Drag and drop the CSMA components from the left onto the correct descriptions on the right.

  Select and Place: