Riverbed 199-01 Online Practice Questions and Exam Preparation

Riverbed 199-01 Online Questions & Answers

• Question 141:

  Refer to the exhibit.

  

  SH3 and SH4 are able to optimize HTTP sessions from Client41 to application host Server31. However, Client41 receives a failure messagE. "ftp connect: Unknown error number" while trying to connect Server32. The same applies to Client42. Note that SH3 and SH4 are in auto-discovery mode. Client41 and Client42 are able to ping Server32. What is the most likely cause of this failure?

  A. The network interface card (NIC) at Server32 is down
  B. The FTP service running in Server32 is down
  C. An outbound access-list specified at R3f0 denies IP traffic from Client41 and Client42
  D. An outbound access-list specified at R3f0 denies FTP control traffic from Client41 and Client42
  E. The routing protocol between R3 and R4 is configured wrong
  B. The FTP service running in Server32 is down

• Question 142:

  Which of the following is NOT supported in Alarm Settings?

  A. Raise alarm when network interface duplex errors are detected
  B. Raise alarm when network interface link errors are detected
  C. Raise alarm when the number of optimized connections exceeds user specified limit
  D. Raise alarm if a software version mismatch is detected in the network
  E. Raise alarm when asymmetric routes are detected
  C. Raise alarm when the number of optimized connections exceeds user specified limit

• Question 143:

  When deploying Interceptor appliances in a parallel cluster what feature must be disabled to ensure packet redirection upon failure?

  A. Fail-to-wire.
  B. Connection forwarding.
  C. Fail-to-block.
  D. Link State Propagation.
  E. WCCP.
  A. Fail-to-wire.

• Question 144:

  When enabling MS-SQL Layer 7 optimizations, what are the best practices to use? (Select 2)

  A. Peering rules specifying the specific MS-SQL server with an accept rule for all other traffic using port 1433
  B. Fixed-target rules specifying the specific MS-SQL server with pass-through rules for all other traffic using port 1433
  C. Auto-discovery specifying the specific MS-SQL server with pass-through rules for all other traffic using port 1433
  D. Server-side out-of-path specifying the specific MS-SQL server with an accept rule for all other traffic using port 1433
  E. No rules are needed; allow it to optimize all MS-SQL traffic
  B. Fixed-target rules specifying the specific MS-SQL server with pass-through rules for all other traffic using port 1433
  C. Auto-discovery specifying the specific MS-SQL server with pass-through rules for all other traffic using port 1433

• Question 145:

  The Optimization service has been disabled on a Steelhead appliance. Which of the following events occur as a result?

  A. LAN and WAN interfaces stop intercepting
  B. Primary interface becomes disabled
  C. AUX interface becomes disabled
  D. The Steelhead appliance reboots
  A. LAN and WAN interfaces stop intercepting

• Question 146:

  When upgrading from a Steelhead 5050 appliance to a Steelhead 6050 appliance what can be migrated to the new appliance? (Select 2)

  A. Datastore
  B. Licenses
  C. Network configuration
  D. Optimization configurations
  E. Serial numbers
  C. Network configuration
  D. Optimization configurations

• Question 147:

  To increase the high availability of a site at a remote office, you decided to install a second Steelhead appliance as an active/active serial cluster. However, after installing the second Steelhead appliance at the remote site, users started complaining about slow access to the data center. You have verified that this is not a duplex issue. At the data center location all users access the Internet which pass-through the Steelhead appliances. What is the most likely problem?

  A. SMB Signing
  B. Oplock issue
  C. The serial cluster Steelhead appliances are peering to each other
  D. Simplified routing was enabled on the secondary Steelhead appliance
  E. The datastore on the Steelhead appliances are wrapping
  C. The serial cluster Steelhead appliances are peering to each other

• Question 148:

  When deploying a Virtual Steelhead appliance, how much extra memory should be allocated for the extra VMware overhead?

  A. 3%
  B. 4%
  C. 5%
  D. 10%
  E. 2%
  C. 5%

• Question 149:

  Which section of the Steelhead appliance Management Console can help identify speed/duplex errors? (Select 2)

  A. View Logs
  B. Current Connections C. Alarm Status
  D. Interface Statistics
  E. Monitored Ports
  A. View Logs
  D. Interface Statistics

• Question 150:

  Adaptive data streamlining provides you:

  A. with the ability to fine tune the data streamlining capabilities, and enables you to obtain the right balance between optimal bandwidth reduction and optimal throughput
  B. with the ability to fine tune the data streamlining capabilities, and enables you to obtain the right balance between optimal bandwidth reduction and optimal acceleration
  C. with the ability to fine tune the compression capabilities, and enables you to obtain the right balance between optimal bandwidth reduction and optimal throughput
  D. with the ability to fine tune the compression capabilities, and enables you to obtain the right balance between optimal bandwidth reduction and optimal acceleration
  A. with the ability to fine tune the data streamlining capabilities, and enables you to obtain the right balance between optimal bandwidth reduction and optimal throughput