You run the command fw tab -t connections -s on both members in the cluster. Both members report differing values for "vals" and "peaks". Which may NOT be a reason for this difference?
A. Synchronization is not working between the two members
B. SGMs in a 61k environment only sync selective parts of the connections table.
C. Heavily used short-lived services have had synchronization disabled for performance improvement.
D. Standby member does not synchronize until a failover is needed.
What would be a reason to use the command cphaosu stat?
A. To determine the number of connections from OPSEC software using Open Source Licenses.
B. To decide when to fail over traffic to a new cluster member.
C. This is not a valid command.
D. To see the policy install dates on each of the members in the cluster.
You run the commands:
fw ctl debug 0
fw ctl debug -buf 32000
Which of the following commands would be best to troubleshoot a clustering issue?
A. fw ctl zdebug -m cluster + all
B. fw ctl debug -m CLUSTER + conf stat
C. fw ctl debug -m cluster + pnote stat if
D. fw ctl kdebug -m CLUSTER all
What are the kernel parameters that control "Magic MACs"?
A. fwha_magic_mac and fw_forward_magic_mac
B. fwha_mac_magic and fw_mac_forward_magic
C. cpha_mac_magic and cp_mac_forward_magic
D. cpha_magic_mac and cpha_mac_forward_magic
How many sync interfaces are supported on Check Point R77 GAiA?
A. 3
B. 4
C. 2
D. 1
Which is NOT a valid upgrade method in an R77 GAiA ClusterXL deployment?
A. Optimal Service Upgrade
B. Full Connectivity Upgrade
C. Minimal Effort Upgrade
D. Automatic Incremental Upgrade
Which of the following is NOT a cphaprob status?
A. "Standby"
B. "Active"
C. "Backup"
D. "Down Attention" (or "Down!" in VSX mode)
What would be a reason for changing the "Magic MAC"?
A. To allow for automatic upgrades.
B. To allow two or more cluster members to exist on the same network.
C. To allow two or more clusters to exist on the same network.
D. To allow the two cluster members to use the same virtual IP address.
Your cluster member is showing a state of "Ready". Which of the following is NOT a reason one would expect for this behaviour?
A. One cluster member is configured for 32 bit and the other is configured for 64 bit
B. CoreXL is configured differently on the two machines
C. The firewall that is showing "Ready" has been upgraded but the other firewall has not yet been upgraded
D. Firewall policy has not yet been installed to the firewall
Which definition best describes the file table.def function? It is a placeholder for:
A. definitions of various kernel tables for Security Gateways.
B. definitions of various kernel tables for Management Servers.
C. user defined implied rules for Security Gateways.
D. user defined implied rules for Management Servers.
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only CheckPoint exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 156-115.77 exam preparations and CheckPoint certification application, do not hesitate to visit our Vcedump.com to find your solutions here.