Cisco 100-101 Online Practice Questions and Exam Preparation

Cisco 100-101 Online Questions & Answers

• Question 201:

  Refer to the exhibit.

  

  A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?

  A. Change the first line to interface fastethernet 0/1.
  B. Change the first line to interface vlan 0/1.
  C. Change the fifth line to ip default-gateway 192.168.17.241.
  D. Change the fifth line to ip route 0.0.0.0 0.0.0.0 192.168.17.1.
  E. Change the sixth line to line con 0.
  C. Change the fifth line to ip default-gateway 192.168.17.241.

  ---

  The default gateway for remote session is 192.168.17.241 and not the one given in the exhibit.

• Question 202:

  A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link.

  

  The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?

  A. The OSPF area is not configured properly.
  B. The priority on R1 should be set higher.
  C. The cost on R1 should be set higher.
  D. The hello and dead timers are not configured properly.
  E. A backup designated router needs to be added to the network.
  F. The OSPF process ID numbers must match.
  D. The hello and dead timers are not configured properly.

  ---

  In OSPF, the hello and dead intervals must match and here we can see the hello interval is set to 5 on R1 and 10 on R2. The dead interval is also set to 20 on R1 but it is 40 on R2.