VMware VCP550 Online Practice Questions and Exam Preparation

VMware VCP550 Online Questions & Answers

• Question 201:

  A vSphere administrator has created a vSphere Standard Switch with one virtual machine port group and one physical uplink. The administrator needs to ensure that the virtual machines on this port group can communicate only with each other.

  What should the administrator do?

  A. Remove the physical uplink from the vSphere Standard Switch
  B. Create a Private VLAN and apply it to the virtual machine port group on the vSphere Standard Switch
  C. Enable Port Security on the vSphere Standard Switch
  D. Enable the Fenced setting on the virtual machine port group
  A. Remove the physical uplink from the vSphere Standard Switch

• Question 202:

  An administrator needs to unmount a datastore that is also used for HA storage heartbeats.

  What is the least disruptive method for an administrator to perform this activity on a slave HA host?

  A. On the Datastore Heartbeating tab, unmount the datastore normally and confirm a new datastore has been selected.
  B. On the Datastore Heartbeating tab, specify an alternate datastore, then unmount the datastore normally.
  C. Disable HA datastore heartbeats, then unmount the datastore.
  D. Reduce the number of heartbeat datastores, then remove the datastore from the heartbeat list.
  B. On the Datastore Heartbeating tab, specify an alternate datastore, then unmount the datastore normally.

• Question 203:

  An administrator has created a Virtual Flash Read Cache and needs to add a total 2TB of capacity to the cache. The administrator has a total of six SSD disks to add, but is unable to add one of the disks.

  What is a likely cause of the problem?

  A. The SSD device size is less than 256GB.
  B. The SSD device size is greater than 4TB.
  C. The SSD device is a local disk.
  D. The SSD device contains existing data.
  B. The SSD device size is greater than 4TB.

• Question 204:

  Which two are supported object types for Update Manager? (Choose two.)

  A. virtual appliances
  B. templates
  C. vApps
  D. hosts
  A. virtual appliances
  D. hosts

• Question 205:

  What is the minimum virtual machine compatibility setting required for a virtual machine to run on a vSphere 5.5 host?

  A. ESXi 5.1 and later
  B. ESXi 3.0 and later
  C. ESXi 4.1 and later
  D. ESXi 3.5 and later
  D. ESXi 3.5 and later

• Question 206:

  An administrator determines that when a host residing in a High Availability (HA) cluster fails, the virtual machines fail to restart on a remaining host, or will only restart after a long delay. Which two conditions would account for this behavior? (Choose two.)

  A. The virtual machines were not protected by vSphere HA at the time the failure occurred.
  B. Distributed Resource Scheduler was not enabled at the time the failure occurred.
  C. There is insufficient spare capacity on hosts with which the virtual machines are compatible.
  D. The virtual machines contain physical Raw Device Mappings.
  A. The virtual machines were not protected by vSphere HA at the time the failure occurred.
  C. There is insufficient spare capacity on hosts with which the virtual machines are compatible.

• Question 207:

  What is a characteristic of Virtual SAN?

  A. It supports Virtual Machine Storage Policies.
  B. It supports multiple Virtual SAN clusters for each host.
  C. It supports native snapshots and SE Sparse disks.
  D. It supports storage attached through USB, Fibre Channel, or iSCSI.
  A. It supports Virtual Machine Storage Policies.

• Question 208:

  The load on a Fully Automated HA/DRS cluster is critically unbalanced. What condition could cause this issue?

  A. DRS is disabled on one or more virtual machines.
  B. The migration threshold is set to Moderate.
  C. Storage vMotion is not enabled on the cluster.
  D. Storage DRS is disabled on the datastore hosting the cluster's virtual machines.
  A. DRS is disabled on one or more virtual machines.

• Question 209:

  An administrator is preparing to install an additional Single Sign-On node on a stand-alone server. What information is required during the installation routine?

  A. Active Directory domain name and credentials
  B. System DSN
  C. Partner Host Name
  D. Lookup Service URL
  C. Partner Host Name

• Question 210:

  Which condition will cause a HA/DRS cluster to display a yellow health indicator?

  A. There are insufficient resources to satisfy the cluster's requirements.
  B. A virtual machine has failed and cannot be restarted in the cluster.
  C. Virtual machine I/O activity in the cluster has reached or exceeded a critical level.
  D. One or more hosts in the cluster has entered maintenance mode.
  A. There are insufficient resources to satisfy the cluster's requirements.