VMware VCP-510 Online Practice Questions and Exam Preparation

VMware VCP-510 Online Questions & Answers

• Question 121:

  An administrator would like to have vCenter take action any time a virtual machine is using over 90% of its available resources for five minutes or longer. Which three actions can be taken by vCenter Server in response to the trigger without running a script? (Choose three.)

  A. Power on a VM
  B. Reboot Guest on VM
  C. Increase Virtual Machine Memory
  D. Migrate a VM
  E. Increase Virtual Machine CPU Shares
  A. Power on a VM
  B. Reboot Guest on VM
  D. Migrate a VM

• Question 122:

  An administrator is configuring an ESXi 5.x host with two dual-port Fibre Channel (FC) HBAs. The FC storage array has four active storage processor ports. Zoning is configured on both fabrics, with ESXi HBA ports and the array ports in the same zone. There are two LUNs with VMFS datastores configured. Using Round Robin multipathing, what is the maximum number of paths that can be used to send data to the VMFS datastores at any given time?

  A. 2
  B. 3
  C. 1
  D. 4
  A. 2

• Question 123:

  A virtual machine failure occurs in a vSphere HA cluster, but the VM is not restarted. No error messages are given. Which two conditions would explain this behavior? (Choose two.)

  A. Monitoring sensitivity was set to Low.
  B. Application Monitoring Only was selected.
  C. The virtual machine has failed three times.
  D. The HA cluster was set up with all defaults.
  C. The virtual machine has failed three times.
  D. The HA cluster was set up with all defaults.

• Question 124:

  An administrator uses VMware Data Recovery to make backups of virtual machines. Checking on the backup jobs that were run the previous evening, the administrator notices that some jobs completed but that other jobs did not. What are two possible causes for the failure? (Choose two.)

  A. The deduplication store had 400GB of available space before the start of the affected jobs.
  B. Eight backup jobs were running simultaneously, causing new jobs to fail to start.
  C. The backup window was not open long enough to retrieve all of the changed blocks.
  D. CPU utilization on the VDR appliance exceeded 90% before one or more jobs executed.
  B. Eight backup jobs were running simultaneously, causing new jobs to fail to start.
  D. CPU utilization on the VDR appliance exceeded 90% before one or more jobs executed.

• Question 125:

  Which virtual disk types are supported on an network attached storage appliance using NFS with hardware acceleration disabled?

  A. Flat disk
  B. Raw Device Mappings
  C. Thick Provision Lazy Zeroed
  D. Thin Provision
  D. Thin Provision

• Question 126:

  What are two valid Resource settings that can be set at the vApp level? (Chose two.)

  A. Network
  B. CPU
  C. Memory
  D. Disk
  B. CPU
  C. Memory

• Question 127:

  An administrator is configuring vMotion in their environment. As part of the implementation, an administrator is examining resource mapping for virtual machines. What is a likely cause of the error shown in the exhibit?

  

  A. vMotion has not been enabled on a VMkernel portgroup.
  B. The administrator has not created a Management network.
  C. vMotion has not been enabled on the Production portgroup.
  D. vMotion has been disabled because there are no other hosts in the cluster with vMotion enabled.
  A. vMotion has not been enabled on a VMkernel portgroup.

• Question 128:

  Which VMware solution uses the security of a vSphere implementation and provides linked-clone technology to virtual desktops?

  A. VMware ACE
  B. VMware View
  C. VMware Workstation
  D. VMware ThinApp
  B. VMware View

• Question 129:

  What are the iSCSI discovery methods that are supported by ESXi hosts

  A. Static Targets, Dynamic Targets
  B. Static Discovery, Send Targets
  C. Static Discovery, Find Targets
  D. Dynamic Discovery, Find Targets
  B. Static Discovery, Send Targets

• Question 130:

  A user attempts a remote SSH connection to a newly-installed ESXi 5.x host to execute some commands. The SSH connection attempt fails, though the user is able to receive a ICMP ping back from the host. What must the administrator do to enable SSH? (Choose two.)

  A. Enable root logon on the ESXi server.
  B. Open the SSH port on the ESXi firewall.
  C. Start the SSH service on the ESXi server.
  D. Create a local user on the ESXi server.
  B. Open the SSH port on the ESXi firewall.
  C. Start the SSH service on the ESXi server.