1. Home
  2. Fortinet
  3. NSE7_EFW-7.0

Fortinet NSE7_EFW-7.0 Online Practice Questions and Exam Preparation

NSE7_EFW-7.0 Exam Details

  • Exam Code
    :NSE7_EFW-7.0
  • Exam Name
    :Fortinet NSE 7 - Enterprise Firewall 7.0
  • Certification
    :Fortinet Certifications
  • Vendor
    :Fortinet
  • Total Questions
    :163 Q&As
  • Last Updated
    :Jul 09, 2026

Fortinet NSE7_EFW-7.0 Online Questions & Answers

  • Question 41:

    Refer to the exhibit, which shows a session table entry.

    Which statement about FortiGate behavior relating to this session is true?

    A. FortiGate redirected the client to the captive portal to authenticate, so that a correct policy match could be made.
    B. FortiGate forwarded this session without any inspection.
    C. FortiGate is performing security profile inspection using the CPU. Most Voted
    D. FortiGate applied only IPS inspection to this session.

  • Question 42:

    Refer to the exhibit, which shows a partial routing table.

    Assuming all the appropriate firewall policies are configured, what two changes would an administrator need to make if they wanted to send traffic from a client directly connected to port3, to a server directly connected to port4? (Choose two.)

    A. Configure route leaking between VRF 12 and VRF 21.
    B. Disable auto-asic-offload as this is not supported between VRF instances.
    C. Configure RIPv2 to exchange route information between the VRF instances.
    D. Configure route leaking between port3 and port4.
    E. Enable SNAT on the relevant firewall policies to prevent RPF check drops.

  • Question 43:

    Refer to the exhibit, which contains partial output from an IKE real-time debug.

    Based on the debug output, which phase 1 setting is enabled in the configuration of this VPN?

    A. auto-discovery-shortcut
    B. auto-discovery-forwarder
    C. auto-discovery-sender
    D. auto-discovery-receiver

  • Question 44:

    View the exhibit, which contains the output of a debug command, and then answer the question below.

    What statement is correct about this FortiGate?

    A. It is currently in system conserve mode because of high CPU usage.
    B. It is currently in FD conserve mode.
    C. It is currently in kernel conserve mode because of high memory usage.
    D. It is currently in system conserve mode because of high memory usage.

  • Question 45:

    Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)

    A. SIP session helper runs in the kernel; SIP ALG runs as a user space process.
    B. SIP ALG supports SIP HA failover; SIP helper does not.
    C. SIP ALG supports SIP over IPv6; SIP helper does not.
    D. SIP ALG can create expected sessions for media traffic; SIP helper does not.
    E. SIP helper supports SIP over TCP and UDP; SIP ALG supports only SIP over UDP.

  • Question 46:

    Refer to the exhibit, which contains partial outputs from two routing debug commands.

    Why is the port2 default route not in the second command's output?

    A. It has a higher priority value than the default route using port1.
    B. It is disabled in the FortiGate configuration.
    C. It has a lower priority value than the default route using port1.
    D. It has a higher distance than the default route using port1.

  • Question 47:

    Which of the following conditions must be met for a static route to be active in the routing table? (Choose three.)

    A. The next-hop IP address is up.
    B. There is no other route, to the same destination, with a higher distance.
    C. The link health monitor (if configured) is up.
    D. The next-hop IP address belongs to one of the outgoing interface subnets.
    E. The outgoing interface is up.

  • Question 48:

    Examine the output of the `get router info bgp summary' command shown in the exhibit; then answer the question below.

    Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

    A. The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.
    B. The TCP session for the BGP connection to 10.200.3.1 is down.
    C. The local peer has received the BGP prefixed from the remote peer.
    D. The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.

  • Question 49:

    Which two statements about bulk configuration changes made using FortiManager CLI scripts are correct? (Choose two.)

    A. When run on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate device.
    B. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
    C. When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.
    D. When run on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate device.

  • Question 50:

    View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question below.

    Based on the debug output, which phase-1 setting is enabled in the configuration of this VPN?

    A. auto-discovery-sender
    B. auto-discovery-forwarder
    C. auto-discovery-shortcut
    D. auto-discovery-receiver

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Fortinet exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your NSE7_EFW-7.0 exam preparations and Fortinet certification application, do not hesitate to visit our Vcedump.com to find your solutions here.