NetApp NCIE-SAN Specialist NS0-506 Questions & Answers

• Question 21:

  A Windows 2012 Server has a 1 GB thin-provisioned LUN in a 10 GB thin-provisioned volume. After copying a 500 MB file to the LUN, you observe the LUN using 500 MB of space in the volume. After deleting the 500 MB file, you observe the LUN is still using 500 MB of space in the volume.

  Which two steps are required to reclaim the space? (Choose two.)

  A. Press Optimize in the Windows Defragment and Optimize Drives utility.

  B. Enable space-allocationon the LUN.

  C. Run TRIM on the host.

  D. Empty the Recycle Bin on the host.

  Correct Answer: C

• Question 22:

  Which command enables the FC protocol on clustered Data ONTAP?

  A. vserverfpolicy enable -vserver -policy name -sequence number

  B. vserverfcp create -vserver -status -adain up

  C. node run node fcadmincongig -e

  D. vserveriscsi create-vserver -target -alias

  Correct Answer: B

• Question 23:

  A new server has been installed in your environment, but it is unable to see its NetApp boot LUN. You have narrowed the problem down to the zoning on your Cisco switch which has the following configuration:

  zone name z_NetAppvsan 400 memberpwwn 20:00:00:25:b5:c0:ff:ee memberpwwn 50:0a:09:84:8d:7c:51:d5 zoneset name zs_NetAppvsan 400 memberz_NetApp zoneset activate name zs_NetAppvsan 400

  What is the problem with your zoning configuration?

  A. The member does not reference the VSAN.

  B. The zone and zoneset names do not match.

  C. The zoneset was improperly activated.

  D. The PWWN for your NetApp LIF is incorrect.

  Correct Answer: D

• Question 24:

  Click the Exhibit button.

  Referring to the exhibit, how many paths to the LUN are visible from the host?

  Exhibit:

  

  A. 16

  B. 8

  C. 24

  D. 32

  Correct Answer: B

• Question 25:

  A customer has a 4-node cluster and wants to use iSCSI for LUN traffic. Which license needs to be installed on the nodes?

  A. iSCSI

  B. SnapRestore

  C. CIFS

  D. FC

  Correct Answer: A

• Question 26:

  A customer has recently deployed a clustered Data ONTAP 8.3 system and is trying to mount LUNs to a Windows 2012 Server using the iSCSI protocol. They are using Cisco Nexus 5548 network switches and the network administrator has informed the storage administrator that the ports are set to switchport mode trunk. The storage administrator has also been informed that the host and storage should be using VLAN 400 for iSCSI traffic. When the storage administrator attempts to add the SVM as an iSCSI target, it fails to connect.

  What is causing the problem?

  A. The storage administrator has not enabled VLAN tagging on the storage ports.

  B. Clustered Data ONTAP 8.3 does not support the iSCSI protocol on a VLAN tagged interface.

  C. Windows 2012 Server does not support the iSCSI protocol on a VLAN tagged interface.

  D. Clustered Data ONTAP 8.3 does not support running iSCSI on a VLAN ID below 1024.

  Correct Answer: A

• Question 27:

  What is installed on your Linux host when you install the Linux Unified Host Utilities 7.0?

  A. drivers and firmware

  B. software iSCSI initiator

  C. SAN Toolkit data collection utility

  D. nSANity

  Correct Answer: C

• Question 28:

  You configure space-reserved LUNs on thick-provisioned volumes, and you want to guarantee overwrites. How would you accomplish this task?

  A. Set the fractional reserve to 0%.

  B. Enable space allocation.

  C. Set the fractional reserve to 100%.

  D. Disable the fractional reserve.

  Correct Answer: A

• Question 29:

  Which objects reside inside an igroup?

  A. host initiators

  B. LUNs

  C. qtrees

  D. volumes

  Correct Answer: A

• Question 30:

  You are troubleshooting a node that had a core dump. The HA partner took over and you successfully performed a giveback. You need to get access to the core files.

  Which two locations will give you access? (Choose two.)

  A. /mroot/etc/crash

  B. https:///spi/

  C. https://

  D. /mroot/etc/log

  Correct Answer: A