NetApp NS0-093 Online Practice Questions and Exam Preparation

NetApp NS0-093 Online Questions & Answers

• Question 1:

  Which two steps are required to replace a drawer in a DS460c shelf? (Choose two.)

  A. Shut down both nodes.
  B. Disconnect the cable chains from the chassis.
  C. Power off the shelf.
  D. Evacuate all drives in the drawer.
  B. Disconnect the cable chains from the chassis.
  D. Evacuate all drives in the drawer.

• Question 2:

  On a NetApp FAS9000 system, which two field replaceable units (FRUs) are supported for replacement without takeover? (Choose two.)

  A. I/O module
  B. DCPM module
  C. caching module
  D. NVRAM module
  A. I/O module
  D. NVRAM module

• Question 3:

  A SAS connection is reporting a single PHY down. What are the two most likely causes? (Choose two.)

  A. improperly seated cable
  B. outdated I/O module (IOM1 firmware
  C. defective cable
  D. an offline shelf in the stack
  A. improperly seated cable
  C. defective cable

• Question 4:

  You have created a case with NetApp Support for an issue with a DS4246 shelf on an ONTAP 9.12.1 system. They have requested that you provide shelf logs. What action do you need to take to collect the shelf logs?

  A. Provide the output of the nodeshell command rdfile/etc/log/shelflog.
  B. Invoke an autosupport of type all using Active IQ Unified Manager.
  C. Invoke a diagnostic AutoSupport with the subsystem storage.
  D. Invoke a diagnostic autosupport with the subsystem log_files.
  C. Invoke a diagnostic AutoSupport with the subsystem storage.

• Question 5:

  You have upgraded your cluster from ONTAP 9.5 software to ONTAP 9.7 software. After two days, you notice that the upgrade is causing issues. You decide to revert to ONTAP 9.5 software. Which two actions do you need to complete before you revert? (Choose two.)

  A. Revert from ONTAP 9.7 software to ONTAP 9.6 software and then to ONTAP 9.5 software.
  B. Delete all Snapshot copies from the past two days.
  C. Reinstall your boot media and install ONTAP 9.5 software.
  D. Wipe your config and restore from backup.
  C. Reinstall your boot media and install ONTAP 9.5 software.
  D. Wipe your config and restore from backup.

• Question 6:

  Which of the following scenarios could result in a NetApp WAFL inconsistency in a RAID DP aggregate?

  A. two disks failing and a block error during reconstruction
  B. rebooting a node during a disk reconstruction
  C. two disks failing within seconds of each other
  D. both party disks failing
  A. two disks failing and a block error during reconstruction

• Question 7:

  Which two ONTAP systems support both SSD and SAS disks? (Choose two.)

  A. AFF C190
  B. FAS2750
  C. AFF A220
  D. FAS8200
  B. FAS2750
  D. FAS8200

• Question 8:

  What are two valid options for uploading a core file from a node that is running ONTAP 9.12.1 software to NetApp for analysis? (Choose two.)

  A. system node autosupport invoke -diagnostic
  B. Download via CIFS and upload to upload.netapp.com.
  C. Download via Service Processor Infrastructure (SPI) and upload to upload.netapp.com.
  D. system node autosupport invoke-core-upload
  B. Download via CIFS and upload to upload.netapp.com.
  D. system node autosupport invoke-core-upload

• Question 9:

  Which two of the following methods are valid ways to access a node which is not booting? (Choose two.)

  A. node management port
  B. cluster management port
  C. Service Processor
  D. serial console
  C. Service Processor
  D. serial console

• Question 10:

  During which two operations is the NVRAM replayed by the high-availability (HA) partner? (Choose two.)

  A. after triggering a sync core
  B. when a node is halted
  C. during a negotiated takeover
  D. when the node loses power
  C. during a negotiated takeover
  D. when the node loses power