Nutanix NCP-MCI-6.5 Online Practice Questions and Exam Preparation

Nutanix NCP-MCI-6.5 Online Questions & Answers

• Question 91:

  An administrator wants to receive an environment summary report when a host failure occurs. Which action would address the administrator's need?

  A. Enable App Discovery
  B. Edit report schedule
  C. Configure an alert policy
  D. Create a playbook
  C. Configure an alert policy

  ---

  Explanation/Reference:

  An alert policy can be configured to send out an environment summary report when a host failure occurs. This can be done by creating a policy that triggers an alert whenever a host fails and then configuring the policy to send out a report that provides a summary of the environment in which the failure occurred. This will allow the administrator to quickly get a view of the environment after a failure occurs, allowing them to take the necessary steps to address the issue. https:// www.nutanix.com/support-services/training-certification/certifications/certification- details-nutanix-certified-professional-multicloud-infrastructure-6_5

• Question 92:

  What Nutanix feature provides effective caching optimization In VDI environments?

  A. Remote Protection Group
  B. Local Protection Group
  C. Snap Clones
  D. Shadow Clones
  D. Shadow Clones

• Question 93:

  An administrator needs to ensure logs, alerts and information is consistent across clusters that are located in different countries. Which service needs to be configured?

  A. SMTP
  B. DNS
  C. SNMP
  D. NTP
  D. NTP

  ---

  Explanation/Reference:

  NTP service needs to be configured to ensure logs, alerts and information is consistent across clusters that are located in different countries. NTP stands for Network Time Protocol and it is used to synchronize the clocks of all the nodes in a cluster1. This helps to maintain accurate timestamps for logs, alerts and other information that are generated by Nutanix clusters1.

• Question 94:

  A customer wants to isolate a group of VMs within their Nutanix environment for security reasons. The customer creates a VM with two NICs to act as a firewall and installs the appropriate software and certificates.

  However, no one from the outside can access the application.

  What is the likely cause of this problem?

  A. A shared volume group must be used by all isolated VMs
  B. More than one NIC cannot be added to a VM
  C. One of the NICs needs to be configured on the internal VLAN
  D. Wireshark is installed on the NAT VM
  C. One of the NICs needs to be configured on the internal VLAN

• Question 95:

  HOTSPOT

  An administrator has created several custom alert policies, which are applied to the same entities. Prism Central displays a message that a similar policy exists. In what order of precedence are overlapping policies evaluated?

  Hot Area:

  

  

  ---

  Explanation/Reference:

• Question 96:

  HOTSPOT

  An administrator needs to shut down an AHV cluster to relocate hardware. The administrator upgrades NCC and runs health checks.

  Which steps should the administrator perform next?

  Item instructions: For each procedure, indicate the order in which that procedure must take place to meet the item requirements.

  Hot Area:

  

  

  ---

  Explanation/Reference:

• Question 97:

  How should an administrator enable secure access to Volumes using a password?

  A. iSER
  B. CHAP
  C. SAML
  D. LDAP
  B. CHAP

  ---

  Explanation/Reference:

  https://portal.nutanix.com/page/documents/details/?targetId=Web-Console- Guide-Prism-v50:wc-block-services-enabling-t.html Provision storage on the Nutanix cluster by creating a volume group. Create a client whitelist to enable access to the volume group by using the IP addresses or client initiator IQNs in a whitelist (as part of the volume group configuration). Create a secret for the volume group if you are using CHAP authentication.

• Question 98:

  Which component can be associated with a storage policy?

  A. Subnet
  B. Catalog
  C. Vm
  D. Category
  A. Subnet
  C. Vm

  ---

  https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide- vpc_2022_6:mul-cluster-storage-policy-summary-view-pc-r.html

• Question 99:

  A Nutanix cluster is equipped with four nodes. Four VMs on this cluster have been configured with a VM-VM anti-affinity policy and are each being hosted by a different node. What occurs to the cluster and these VMs during an AHV upgrade?

  A. One node hosts two VMs while the node being upgraded is in maintenance mode.
  B. One VM out of the four powers down when the node hosting it reboots.
  C. The AHV pre-upgrade checks fail until the administrator disables the anti-affinity policy.
  D. The AHV pre-upgrade checks fail until the four VMs are powered off.
  C. The AHV pre-upgrade checks fail until the administrator disables the anti-affinity policy.

• Question 100:

  An administrator would like to leverage the Reliable Event Logging Protocol (RELP) with their Remote Syslog Server. After completing the configuration, it is observed that RELP logging is not working as expected. What is the likely cause of this issue?

  A. The cluster does not have RELP installed.
  B. The GENESIS was the only one chosen to forward log information.
  C. The Remote Syslog Server was configure using TCP as the protocol.
  D. The remote server does not have rsyslog-relp installed.
  D. The remote server does not have rsyslog-relp installed.