Juniper JN0-361 Online Practice Questions and Exam Preparation

Juniper JN0-361 Online Questions & Answers

• Question 381:

  What is required on the egress and ingress devices to transport IPv6 traffic across an IPv4 network?

  A. An IP-IP interface
  B. A TE tunnel interface
  C. A GRE tunnel interface
  D. A 6to 4 tunnel interface
  C. A GRE tunnel interface

• Question 382:

  Which statement is true regarding default MPLS label handling?

  A. A router that pops a label from a label stack always pushes a new label on the packet
  B. A router that pops a label from a label stack forwards a frame based on the label that was popped.
  C. A router that pops a label from a label stack forwards a frame based on the underlying destination IP address.
  D. A router that pops a label from a label stack applies class of service based on the IP header to ToS bits.
  C. A router that pops a label from a label stack forwards a frame based on the underlying destination IP address.

• Question 383:

  R8 is an OSPF router connected to both Area 0 and Area 2. Area 2 has been configured as a totally stubby area. Which three LSA types does R8 suppress from Area 2? (Choose three.)

  A. Router LSA
  B. Network LSA
  C. External LSA
  D. Summary LSA
  E. ASBR Summary LSA
  C. External LSA
  D. Summary LSA
  E. ASBR Summary LSA

• Question 384:

  Which two values displayed in the output from the show spanning-tree MSTP configuration command must match on all switches participating in the same MSTP region? (Choose two)

  A. root bridge identifier
  B. authentication checksum
  C. context identifier
  D. configuration digest
  C. context identifier
  D. configuration digest

• Question 385:

  Which two statements are correct about neighbor discovery in IPv6? (Choose two.)

  A. Neighbor discovery relies on ARP to find neighbors on a local link.
  B. A neighbor is considered reachable when the neighboring device responds to a neighbor solicitation message.
  C. A neighbor is considered reachable when the neighboring device responds to a router solicitation message.
  D. Neighbor discovery does not use ARP to find neighbors on a local link.
  B. A neighbor is considered reachable when the neighboring device responds to a neighbor solicitation message.
  D. Neighbor discovery does not use ARP to find neighbors on a local link.

• Question 386:

  Click the Exhibit button

  policy-options {

  policy-statement load-balance {

  then {

  load-balance per-packet;

  }

  }

  }

  When the configuration shown in the exhibit is applied, which routes in the forwarding table will begin load-balancing packet flows?

  A. all routes in the forwarding table
  B. all OSPF routes in the forwarding table
  C. all BGP routes in the forwarding table
  D. all RFC 1918 routes in the forwarding table
  A. all routes in the forwarding table

• Question 387:

  Which OSPF LSA type is sent from the ABR to describe an ASBR that is in an area to which it is connected?

  A. Type 7
  B. Type 5
  C. Type 4
  D. Type 3
  C. Type 4

• Question 388:

  Click the Exhibit button

  

  You have two routers connected over a Gigabit Ethernet link as shown in the exhibit It is required that an IS-IS adjacency be established without the need for a designated intermediate system (DIS) Which configuration statement entered on both routers will achieve this goal?

  A. set interface ge-0/0/2 unit 0 family iso no-dis
  B. set interface ge-0/0/2 unit 0 family iso point-to-point
  C. set protocols isis interface ge-0/0/2.0 no-dis
  D. set protocols isis interface ge-0/0/2.0 point-to-point
  D. set protocols isis interface ge-0/0/2.0 point-to-point

• Question 389:

  Which three statements are correct about VRRP? (Choose three.)

  A. It requires speakers to be configured with BFD.
  B. It uses a virtual router MAC address for LAN communications.
  C. It uses multicast address 224.0.0.18.
  D. It is confined to the local network with a TTL of 255.
  E. It uses the virtual router's lo0 address for LAN communications.
  B. It uses a virtual router MAC address for LAN communications.
  C. It uses multicast address 224.0.0.18.
  D. It is confined to the local network with a TTL of 255.

• Question 390:

  Click the exhibit.

  

  Referring to the exhibit, which configuration must be set on R2 to from a Level 1 IS-IS adjacency with R1?

  A. Set interfaces lo0 unit 0 family iso address 49.0001.3415.0010.0250.0000.0046.00
  B. Set interfaces lo0 unit 0 family iso address 49.0002.3414.0010.0250.0000.0046.00
  C. Set interfaces lo0 unit 0 family iso address 49.0002.3415.0010.0250.0000.0046.00
  D. Set interfaces lo0 unit 0 family iso address 49.0001.3414.0010.0250.0000.0046.00
  A. Set interfaces lo0 unit 0 family iso address 49.0001.3415.0010.0250.0000.0046.00