JN0-361 Exam Details

  • Exam Code
    :JN0-361
  • Exam Name
    :Service Provider Routing and Switching, Specialist (JNCIS-SP)
  • Certification
    :Juniper Certifications
  • Vendor
    :Juniper
  • Total Questions
    :542 Q&As
  • Last Updated
    :May 25, 2026

Juniper JN0-361 Online Questions & Answers

  • Question 401:

    Which type of BGP message is used to perform a soft clearing of a BGP session?

    A. refresh
    B. update
    C. notification
    D. open

  • Question 402:

    You are troubleshooting an OSPF adjacency that is stuck in the ExStart state. What would be the correct step to resolve the problem?

    A. Look for a mismatched IP subnet or mask.
    B. Determine whether the neighbor is a DR-Other.
    C. Determine whether the hello and dead intervals are the same on both sides.
    D. Review the MTU settings to ensure that they match.

  • Question 403:

    What are two ways to assign an IPv6 to an interface? (Choose two.)

    A. Use static addressing.
    B. Use neighbor discovery.
    C. Use an auto-configuration based on the interface MAC address.
    D. Use an IPv6 routing protocol.

  • Question 404:

    By default, how often does a designated intermediate system (DIS) send IS-IS hello messages on a LAN?

    A. every 3 seconds
    B. every 9 seconds
    C. every 10 seconds
    D. every 30 seconds

  • Question 405:

    Which two formats are valid route distinguisher formats? (Choose two.)

    A. :
    B. :
    C. :
    D. :

  • Question 406:

    You are using RSVP to signal an MPLS LSP. Which statement is true in this scenario?

    A. LSPs can be configured without any traffic engineering constraints.
    B. The traffic engineering database must be used for all LSPs.
    C. A primary path must be configured to establish an LSP.
    D. A secondary path must be configured to establish an LSP.

  • Question 407:

    Click the Exhibit button.

    Which statement is true regarding the output shown in the exhibit?

    A. The configuration supports IPv6 multicast routes.
    B. The configuration supports IPv6 unicast routes.
    C. The configuration supports IPv4 unicast routes.
    D. The configuration supports IPv4 multicast routes.

  • Question 408:

    Which two statements are true about unified in-service software upgrade (ISSU)? (Choose two.)

    A. Unified ISSU is supported only on dual Routing Engine (RE) platforms
    B. To perform a unified ISSU, it is not necessary for the master RE and backup RE to be running the same version of the Junos OS
    C. Unified ISSUE causes minimal disruption on both the control and forwarding planes
    D. Graceful Routing Engine Switchover (GRES) and nonstop active routing (NSR) must be enabled to perform a unified ISSU

  • Question 409:

    Which label operation is performed by an MPLS ingress router?

    A. Pop
    B. Push
    C. Replace
    D. Swap

  • Question 410:

    Which three are valid IPv6 extension headers? (Choose three.)

    A. multicast header
    B. authentication header
    C. autoconfiguration options
    D. fragment
    E. hop-by-hop options

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Juniper exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your JN0-361 exam preparations and Juniper certification application, do not hesitate to visit our Vcedump.com to find your solutions here.