Juniper JN0-130 Online Practice Questions and Exam Preparation

Juniper JN0-130 Online Questions & Answers

• Question 41:

  In a Bridged 1483 network, which CLI commands are used to baseline an IP interface on ATM 6/1.1 and display recent IP transmit and receive statistics?

  A. clear ip interface atm 6/1.1 show ip interface atm 6/1.1
  B. baseline atm interface atm 6/1.1 show ip interface atm 6/1.1
  C. clear ip interface atm 6/1.1 show ip interface atm 6/1.1 delta
  D. baseline atm interface atm 6/1.1 show ip interface atm 6/1.1 delta
  D. baseline atm interface atm 6/1.1 show ip interface atm 6/1.1 delta

• Question 42:

  What are three methods to apply a L2TP Tunnel Switch Profile? (Choose three.)

  A. aaa domain-map
  B. radius attributes
  C. tunnel groups
  D. tunnel services profile
  E. l2tp destination profile
  A. aaa domain-map
  B. radius attributes
  C. tunnel groups

• Question 43:

  If all OSPF routers on a broadcast network have the same OSPF priority, which parameter is used to determine the new BDR at the time of a DR failure?

  A. area ID
  B. router ID
  C. loopback address
  D. IP address of interface on broadcast network
  B. router ID

• Question 44:

  Which three LSA types can be flooded within an OSPF stub area? (Choose three.)

  A. Type 1
  B. Type 2
  C. Type 3
  D. Type 5
  E. Type 7
  A. Type 1
  B. Type 2
  C. Type 3

• Question 45:

  Which IS-IS authentication method is supported on the ERX Edge Router?

  A. simple password
  B. HMAC message digest 5
  C. Password Authentication Protocol
  D. Challenge Handshake Authentication Protocol
  B. HMAC message digest 5

• Question 46:

  Which CLI command displays the status of a PPP over Ethernet subinterface?

  A. show pppoe interface
  B. show ppp int state up
  C. show ip interface brief
  D. show pppoe subinterface
  D. show pppoe subinterface

• Question 47:

  What is true about a Bypass Tunnel in MPLS Fast Reroute?

  A. Only configured on the egress router.
  B. Only configured on the ingress router.
  C. Is pre-signalled to reduce packet loss.
  D. Must intersect the primary LSP at two locations.
  D. Must intersect the primary LSP at two locations.

• Question 48:

  With the following CLI command output performed on an LNS: show l2tp session L2TP session 1/to-Denver/2 is up Which two statements are correct? (Choose two.)

  A. This command was done on the LNS.
  B. This command was done on the LAC.
  C. The 1 defines the destination number.
  D. The 1 defines the session number.
  B. This command was done on the LAC.
  C. The 1 defines the destination number.

• Question 49:

  An authentication request for a PPP over ATM client has been returned to the router with an address of 255.255.255.254. What does this indicate to the router?

  A. A static IP address is used.
  B. An unnumbered address is used.
  C. The returned RADIUS address is used.
  D. The IP address-pool configuration is used.
  D. The IP address-pool configuration is used.

• Question 50:

  Which set of configuration commands configures an ATM PVC to support only PPPoE service?

  A. erx1:vr2(config)# profile ip-ppp-pppoe-info erx1:vr2(config-profile)#ip access-route erx1:vr2(config-profile)#ppp auth chap erx1:vr2(config-profile)#pppoe sessions 5 erx1:vr2(config-profile)#exit erx1:vr2(config)#interface atm 5/1.13 erx1:vr2(config-subif)#tm pvc 13 0 113 aal5autoconfig erx1:vr2(config-subif)#profile ppp ip-ppp-pppoe-info erx1:vr2(config-subif)#auto-configure pppoe erx1:vr2(config-subif)#auto-configure ppp
  B. erx1:vr2(config)# profile ip-ppp-pppoe-info erx1:vr2(config-profile)#ip access-route erx1:vr2(config-profile)#ppp auth chap erx1:vr2(config-profile)#pppoe sessions 5 erx1:vr2(config-profile)#exit erx1:vr2(config)#interface atm 5/1.13 erx1:vr2(config-subif)#atm pvc 13 0 113 aal5autoconfig erx1:vr2(config-subif)#profile ppp ip-ppp-pppoe-info
  C. erx1:vr2(config)# profile ip-ppp-pppoe-info erx1:vr2(config-profile)#ip access-route erx1:vr2(config-profile)#ppp auth chap erx1:vr2(config-profile)#pppoe sessions 5 erx1:vr2(config-profile)#exit erx1:vr2(config)#interface atm 5/1.13 erx1:vr2(config-subif)#atm pvc 13 0 113 aal5autoconfig erx1:vr2(config-subif)#profile pppoe ip-ppp-pppoe-info erx1:vr2(config-subif)#auto-configure pppoe
  D. erx1:vr2(config)# profile ip-ppp-pppoe-info erx1:vr2(config-profile)#ip access-route erx1:vr2(config-profile)#ppp auth chap erx1:vr2(config-profile)#pppoe sessions 5 erx1:vr2(config-profile)#exit erx1:vr2(config)#interface atm 5/1.13 erx1:vr2(config-subif)#profile any ip-ppp-pppoe-info erx1:vr2(config-subif)#auto-configure pppoe erx1:vr2(config-subif)#auto-configure ppp
  C. erx1:vr2(config)# profile ip-ppp-pppoe-info erx1:vr2(config-profile)#ip access-route erx1:vr2(config-profile)#ppp auth chap erx1:vr2(config-profile)#pppoe sessions 5 erx1:vr2(config-profile)#exit erx1:vr2(config)#interface atm 5/1.13 erx1:vr2(config-subif)#atm pvc 13 0 113 aal5autoconfig erx1:vr2(config-subif)#profile pppoe ip-ppp-pppoe-info erx1:vr2(config-subif)#auto-configure pppoe