HP HPE6-A44 Online Practice Questions and Exam Preparation

HP HPE6-A44 Online Questions & Answers

• Question 141:

  An administrator has a cluster of Aruba Mobility Controllers (MCs). The administrator wants to manually reboot one of the controllers. Before rebooting, which command should the administrator use to move the APs?

  A. apmove
  B. lc-cluster move ap
  C. active-ap-rebalance
  D. active-ap-lb
  B. lc-cluster move ap

• Question 142:

  An administrator configures a port on a RAP through the association of an AAA profile with 802.1X authentication to a RAP Ethernet port. This port connects to a switch with user desktops attached. The administrator notices that when users connect wirelessly to the RAP, a user role correctly restricts their traffic. But, when users connect with their wired desktops, they are assigned an initial role and routed to a Captive Portal page.

  What must the administrator do to enable desktop usage based on the user's role assignment?

  A. Implement ACLs on the RAP port.
  B. Apply a server-derived role policy to the RAP port.
  C. Identify the RAP port as untrusted.
  D. Map the RAP port to an authentication profile.
  B. Apply a server-derived role policy to the RAP port.

• Question 143:

  Refer to the exhibit.

  

  What can be determined from the command output shown in the exhibit?

  A. The synchronized data is protected by VRRP.
  B. The command was executed on the standby Mobility Master (MM).
  C. The synchronization period is at its default value.
  D. The other Mobility Master (MM) is the active license server.
  D. The other Mobility Master (MM) is the active license server.

• Question 144:

  An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.274.426. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?

  A. Nodelist
  B. Servername
  C. Master_ip
  D. Cfg_lms
  A. Nodelist

• Question 145:

  Refer to the exhibit.

  

  What can an administrator determine from this Aruba device output?

  A. A switch is connected to a standalone Mobility Controller.
  B. An AP is connected to a Mobility Controller in a cluster.
  C. An AP is connected to a standalone Mobility Controller.
  D. A switch is connected to a Mobility Controller in a cluster.
  D. A switch is connected to a Mobility Controller in a cluster.

• Question 146:

  Which protocol communicates RF neighborhood information to an Aruba Mobility Master (MM) for use by AirMatch?

  A. GRE
  B. PAPI
  C. SNMP
  D. AMON
  D. AMON

• Question 147:

  In a VPN that uses certificate-based authentication, which component must be configured on the Mobility Master (MM) to allow a RAP to successfully connect to a Mobility Controller (MC)?

  A. RAP VPN username and password
  B. WLAN and new RAP group
  C. RAP IPSec pre-shared key
  D. RAP whitelist
  D. RAP whitelist

• Question 148:

  An administrator wants to temporarily deny login access who fail 802.1x authentication functions three or more times. Which process will the administrator need to configure?

  A. EAP termination
  B. blacklisting
  C. captive portal
  D. fail through
  A. EAP termination

• Question 149:

  Refer to the exhibit.

  

  An administrator supports a RAP at a branch office shown in the exhibit. The company has one Mobility Controller (MC) at the Primary DMZ site and one at the Secondary DMZ site. The RAP is configured to connect to only the MC at the Primary DMZ site. A network outage with the ISP at the Primary DMX site causes the RAP to reboot. Upon reboot, the RAP cannot build a tunnel to the Secondary DMZ site MC because the administrator forgot to add the Second LMS IP address to the AP Group configuration. Once the RAP can successfully connect, the administrator can add the Secondary DMZ MC as a backup LMS to fix the AP Group.

  What should the administrator implement to allow the RAP to connect to the MC at the Secondary DMZ site while the outage at the primary site persists?

  A. Dynamic discovery through DHCP Option 43
  B. Static configuration from apboot mode
  C. Dynamic discovery through DHCP Option 60
  D. Dynamic discovery through multicast ADP
  A. Dynamic discovery through DHCP Option 43

• Question 150:

  An AP connects to a controller. Then, the AP loses power and reboots.

  Which parameters will the AP remember and use from its initial connection? (Select two.)

  A. AP group
  B. Server IP
  C. AP IP address and subnet mask
  D. Mobility Master IP
  E. AirWave server name
  A. AP group
  C. AP IP address and subnet mask