HP HPE Technical Certification HPE2-K45 Questions & Answers

• Question 1:

  What happens if an HPE mniStack Virtual Controller (VC) fails in a multi-node HPE SimpliVrty cluster?

  A. All VMs on the node restart in a node where the replica resides.

  B. HPE SimpliVity Intelligent Workload ptimizer restores the VC from backups.

  C. The IP address of the VC fails over to another HPE SimpliVity node.

  D. All VMs on the node go on standby mode to avoid data loss.

  Correct Answer: A

• Question 2:

  A customer is planning HPE Storence integration with HPE SimpliVity. What is a major consideration for this integration?

  A. Number of HPE Storence/SimpliVity integration licenses

  B. Number of the stores configured with HPE Simplicity

  C. Physical location of HPE Storence

  D. Limited support from software-optimized HPE SimpliVity models

  Correct Answer: D

• Question 3:

  What is the difference between crash consistent and application consistent cloning methods?

  A. Application-consistent clones allow the pending 10 operations to finish before committing them to the database.

  B. Both methods are the same; the only difference is speed of cloning.

  C. Crash consistent method should be used only for the virtual machines with Fault Tolerance enabled.

  D. Application consistent method is available only for Linux operating systems.

  Correct Answer: A

• Question 4:

  Which functionality does HPE InfoSight for HPE SimpliVity provide?

  A. balance workloads across HPE SimpllVity nodes based on utilization

  B. recommendation for guest operating system settings optimization

  C. automated firmware and software upgrades for registered customers

  D. monitoring of virtual machine latency

  Correct Answer: A

• Question 5:

  Refer to exhibit:

  

  You are using Restore Virtual Machine for a given virtual machine. Which result is achieved by thrs operation?

  A. Virtual machine boot partition mapped as IS image to another VM

  B. New snapshot added to existing virtual machine

  C. New linked-clone created

  D. New virtual machine created out of this backup

  Correct Answer: C

• Question 6:

  A user deleted a file from Linux based virtual machine.

  Which HPE SimpliVity data protection feature can be leveraged to recover the flie?

  A. Restoring a virtual machine from the backup

  B. Moving a virtual machine from DR site to the primary site

  C. Reverting to the SimpliVity snapshot D. Using file level restore option

  Correct Answer: A

• Question 7:

  You try to delete an existing datastore, but the operation fails. What is a likely cause of the failure?

  A. The datastore is marked as read-only.

  B. The FC connection between the host and array has failed.

  C. The management network for a host is disconnected.

  D. This datastore is not added to your scope.

  Correct Answer: A

• Question 8:

  What does HPE Reference Architectures for HPE Simplicity provide?

  A. solution pricing and possible discounts

  B. recommended hardware configuration in ne Config Advanced (CA) format

  C. validated configuration for a specific workload

  D. comparison with equivalent competitor offerings

  Correct Answer: C

• Question 9:

  A customer plans to use HPE SimpliVity RapidDR, but is concerned about vCenter Server license cost. In which deployment scenario is only a single vCenter Server required?

  A. when less than 600 VMs is covered with a single recovery plan

  B. when Enhanced Linked Mode is enabled for vCenter

  C. when Intelligent Workload ptimizer is disabled

  D. when federation is managed centrally

  Correct Answer: D

• Question 10:

  A customer is interested in HPE SimpliVity nodes that support NVIDIA Tesla T4 GPUs. Which models meet the customer needs? (Select two.)

  A. HPE SimpliVity 325 Gen10

  B. HPE SimpliVity 380 Gen10

  C. HPE SimpliVity 2600

  D. HPE SimpliVity 380 Gen10 G

  E. HPE SimpliVity 380 Gen10 SFFH

  Correct Answer: AB