HP HPE2-K42 Online Practice Questions and Exam Preparation

HP HPE2-K42 Online Questions & Answers

• Question 1:

  How should the All-Flash shelf be connected to the controller shelf?

  A. Cable the All-Flash shelf directly to the last disk shelf.
  B. Cable the All-Flash shelf directly to the controller shelf.
  C. Use high performance SAS expanders.
  D. Cable the All-Flash shelf directly to the first disk shelf.
  B. Cable the All-Flash shelf directly to the controller shelf.

• Question 2:

  Which prerequisites must be fulfilled before starting the array initialization? (Choose three)

  A. HPE Nimble Windows Toolkit installed on a server/laptop.
  B. Ensure your laptop/server IP has a static IP address configured on the same subnet as the array management interface.
  C. Array updated to the latest firmware.
  D. All switch configurations done like flow control and spanning tree.
  E. Array registered in InfoSight based on the serial number.
  F. HPE Service Processor deployed
  A. HPE Nimble Windows Toolkit installed on a server/laptop.
  B. Ensure your laptop/server IP has a static IP address configured on the same subnet as the array management interface.
  C. Array updated to the latest firmware.

• Question 3:

  Which replication scenarios does SmartReplicate support? (Select three.)

  A. reciprocal (bi-directional)
  B. primary to DR
  C. synchronous long distance
  D. one to many
  E. many to one
  A. reciprocal (bi-directional)
  B. primary to DR
  E. many to one

• Question 4:

  How is SmartReplicate licensed?

  A. per array
  B. free of charge
  C. per target
  D. based on capacity (per 1TB)
  B. free of charge

• Question 5:

  What does each AF-Series data chunk contain? (Select three.)

  A. metadata
  B. triple parity
  C. hash data
  D. parity
  E. ECC
  F. data
  A. metadata
  D. parity
  F. data

• Question 6:

  Which statement is correct about HPE InfoSight?

  A. InfoSight is included with all HPE Nimble arrays for no additional cost.
  B. InfoSight is enabled for all arrays with active ProActive Care contracts.
  C. InfoSight is available as plug-in for VMWare vCenter and Microsoft SystemCenter.
  D. InfoSight is accessible through the HPE Service Processor.
  A. InfoSight is included with all HPE Nimble arrays for no additional cost.

• Question 7:

  Which parameters are configured during the initial array configuration? (Choose three.)

  A. Subnets
  B. SNMP settings
  C. Firewall Port settings
  D. Replication partners
  E. NTP servers
  F. DNS servers
  A. Subnets
  E. NTP servers
  F. DNS servers

• Question 8:

  What is the size of a sequential stripe write for the AF-Series?

  A. 8MB
  B. 10MB
  C. 256MB
  D. 1GB
  B. 10MB

• Question 9:

  DRAG DROP

  List basic replication steps in the correct order.

  Select and Place:

  

  

• Question 10:

  What are the recommended tests you should run after the initial setup? (Choose two.)

  A. zoning validation
  B. email alert setup test
  C. data access verification
  D. controller failover test
  C. data access verification
  D. controller failover test