Huawei HC-224 Online Practice Questions and Exam Preparation

Huawei HC-224 Online Questions & Answers

• Question 471:

  Which statements about the relationship between GVRP and GARP are true? (Select 2 Answers)

  A. GVRP, GARP, and GMRP are the standards of the same type.
  B. GVRP and GARP are defined by IEEE 802.1p.
  C. GVRP is based on GARP, and is an application of GARP.
  D. GVRP is a new definition of GARP.
  B. GVRP and GARP are defined by IEEE 802.1p.
  C. GVRP is based on GARP, and is an application of GARP.

• Question 472:

  Which is the default network mask length of 219.25.23.56?

  A. 8
  B. 16
  C. 24
  D. 32
  C. 24

• Question 473:

  Which of the following statements about Flush packets in a Smart Link group are true? (Select 3 Answers)

  A. A Smart Link group sends Flush packets to instruct other devices to update the address table.
  B. Flush packets use IEEE 802.3 encapsulation.
  C. The destination MAC address of Flush packets is an unknown unicast address, which is used to distinguish protocols.
  D. The destination MAC address of Flush packets is a special multicast address, which is used to distinguish protocols.
  A. A Smart Link group sends Flush packets to instruct other devices to update the address table.
  B. Flush packets use IEEE 802.3 encapsulation.
  C. The destination MAC address of Flush packets is an unknown unicast address, which is used to distinguish protocols.

• Question 474:

  In a Land attack, the source address and destination address of an SYN packet are both the IP address of the attacked object or a loopback address.

  A. True
  B. False
  A. True

• Question 475:

  In a switching network that has been enabled with STP protocol, the priorities of all the switches are the same. The MAC address of switch1 is 00-e0-fc-00-00-40, MAC address of switch2 is 00- e0-fc-00-00-10, MAC address of switch3 is 00e0-fc-00-00-20, and MAC address of switch4 is 00- e0-fc-00-00-80. Which of the switches will be elected as the Root Bridge?

  A. Switch1
  B. Switch2
  C. Switch3
  D. Switch4
  B. Switch2

• Question 476:

  An ACL is used to match routing information or data packet addresses so as to filter out the unmatched routing information or data packets.

  A. True
  B. False
  A. True

• Question 477:

  Which of the following routing protocols support import-route? (Select 3 Answers)

  A. OSPF
  B. RIP
  C. BGP
  D. Static
  A. OSPF
  B. RIP
  C. BGP

• Question 478:

  Which of the following statements are correct regarding intra-area route calculation of OSPF? (Select 2 Answers)

  A. Every OSPF router only uses one Router LSA to describe local active link state for one area.
  B. Every OSPF uses more than one Router LSA to describe local active link state for one area.
  C. One Router LSA only describes one link.
  D. One Router LSA describes more than one link.
  A. Every OSPF router only uses one Router LSA to describe local active link state for one area.
  D. One Router LSA describes more than one link.

• Question 479:

  On the MSTP network as shown in the figure, what is the role of the switch in MSTI 1 according to the configuration?

  A. Root switch
  B. Slave switch
  C. Non-root switch
  D. None of the above
  A. Root switch

• Question 480:

  Which of the following standards defines STP?

  A. 802.1J
  B. 802.1X
  C. 802.1D
  D. 802.1P
  C. 802.1D