Huawei H35-210 Online Practice Questions and Exam Preparation

Huawei H35-210 Online Questions & Answers

• Question 311:

  (single) Is the following description correct? The link layer defines electrical and mechanical processes and functions to enable activation, maintenance, and removal of lines when systems are connected at both ends.

  A. True
  B. False
  B. False

• Question 312:

  (single) Which of the following commands is used to shut down the sybase primary server?

  A. shutdown SYS_MAIN
  B. shutdown SYS
  C. shutdown
  D. Shutdown
  C. shutdown

• Question 313:

  (single) Which of the following statements about 802. 1Q is incorrect?

  A. The TPID value in the A.802. 1Q Ethernet frame structure is 8100.
  B. In theory, the VLAN ID ranges from 0 to 4095.
  C. There are only 4 VLAN priorities in the 802. 1Q Ethernet frame structure.
  D. 802. 1Q Ethernet frame is 4 bytes more than ordinary Ethernet frame
  C. There are only 4 VLAN priorities in the 802. 1Q Ethernet frame structure.

• Question 314:

  (single) What are the maximum split ratios supported by MA5680T H801GPBC and H802GPBD?

  A. 1:32, 1:64
  B. 1:64, 1:64
  C. 1:64, 1:128
  D. 1:28, 1:128
  C. 1:64, 1:128

• Question 315:

  (single) Is the following description correct? The MA5600T SCUN provides one maintenance network port, one serial port, one environmental monitoring port, and eight GE interfaces.

  A. True
  B. False
  B. False

• Question 316:

  GPON is an Ethernet-based passive optical access technology that complies with IEEE 802. 3ah.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 317:

  Which of the following methods does the (multiple) VLAN division?

  A. Based on the port
  B. Based on MAC address
  C. Based on the agreement
  D. Based on physical location
  A. Based on the port
  B. Based on MAC address
  C. Based on the agreement

• Question 318:

  (single) What is the correct correspondence between the IP address and the MAC address in a broadcast domain?

  A. An IP address can correspond to multiple MAC addresses
  B. A MAC address can only correspond to one IP address.
  C. A MAC address can correspond to multiple IP addresses
  D. None of the above
  C. A MAC address can correspond to multiple IP addresses

• Question 319:

  (single) Which of the following descriptions is incorrect when performing an optical interface average transmit optical power test?

  A. The optical connector on the fiber connector and the optical interface board panel is clean and well connected.
  B. Optical power meter is calibrated
  C. Connect one end of the test pigtail of the optical power meter to the "Rx" port of the optical interface board, and connect the other end of the pigtail to the optical power meter.
  D. Repeat multiple times to check whether the measured maximum and minimum values of the transmitted optical power meet the technical requirements.
  C. Connect one end of the test pigtail of the optical power meter to the "Rx" port of the optical interface board, and connect the other end of the pigtail to the optical power meter.

• Question 320:

  (single) In the MA5600, which of the following boards does not support the "board reset" operation?

  A. VEDA
  B. SHEA
  C. SCU
  D. ADEF
  C. SCU