Huawei H35-210 Online Practice Questions and Exam Preparation

Huawei H35-210 Online Questions & Answers

• Question 201:

  The ADSL2+ is an extension of the ADSL technology. It supports a maximum downstream rate of 24 Mbit/s and an upstream rate of 2. 5 Mbit/s. The maximum transmission distance can reach 6. 5 km.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 202:

  (single) Which of the following H.248 protocol message types can be initiated by the MG?

  A. ServiceChange
  B. AuditCapabilities
  C. AuditValue
  D. Modify
  A. ServiceChange

• Question 203:

  (Single) What kind of domain can a VLAN be considered?

  A. Conflict domain
  B. Broadcast domain
  C. Administrative domain
  D. Physical area
  B. Broadcast domain

• Question 204:

  (single) Passive Optical Network (PON) is a single-fiber bidirectional optical access network with what structure?

  A. Chain type
  B. Ring type
  C. Tree type
  D. mesh type
  C. Tree type

• Question 205:

  Which of the following methods can be used to test the reset of an OLT board?

  A. Hot swap the board and check whether the board works properly after reset.
  B. Press the RESET button on the control board handle to forcibly reset the control board, and check whether the board works properly after reset.
  C. Run the board reset command to reset a service board, and check whether the service board works properly after being reset.
  D. All of the above
  D. All of the above

• Question 206:

  The routing table of a router contains the following two entries:

  Destination/Mask Protocol Pre Cost Nexthop Interface 9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial0 9.1.0.0/16 RIP 100 5 2. 2. 2. 2 Ethernet0

  If the router needs to forward packets with the destination address of 9.1.4. 5, which of the following statements is correct?

  A. The router selects the first route, because the priority of OSPF is higher.
  B. The router selects the second route, because this route matches the destination address 9.1.4. 5 more accurately.
  C. The router selects the second route, because the metric of RIP is smaller.
  D. The router selects the second route, because the outbound interface is Ethernet0, which is faster than Serial0.
  B. The router selects the second route, because this route matches the destination address 9.1.4. 5 more accurately.

• Question 207:

  (single) Which of the following is not part of the PON network system?

  A. OLT
  B. OAM
  C. ODN
  D. ONU
  B. OAM

• Question 208:

  Generally, an OLT is a switch or router and a multi-service provisioning platform.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 209:

  When adding an ONU to the OLT, if Control flag is deactive, run the ont activate command in GPON port mode to activate the ONU.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 210:

  When adding an ONT to the OLT, you need to:

  A. Configure a DBA profile.
  B. Configure an ONT service profile.
  C. Add an ONT and bind a profile.
  D. Configure an ONT line profile.
  C. Add an ONT and bind a profile.