Huawei H35-210 Online Practice Questions and Exam Preparation

Huawei H35-210 Online Questions & Answers

• Question 131:

  (single) If the other SNMP parameters are configured correctly, how can the device's Trap source address be configured to ensure that the NMS can receive device alarms?

  A. trap source address is set to 127. 0.0.1
  B. trap source address is set to loopback address
  C. The trap source address is set to the address used by the NMS to add the device.
  D. All of the above can be.
  C. The trap source address is set to the address used by the NMS to add the device.

• Question 132:

  (single) Which of the following commands is used to check whether the running status of all boards in the MA5600T/MA5680T 0 is normal?

  A. display board 0
  B. display frame info 0
  C. display board info 0
  D. display frame info 0/0
  A. display board 0

• Question 133:

  If you want to test the optical transmit power of the ONU, connect a common power meter to the upstream port of the ONU and select the 1310 nm wavelength to read the power value.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 134:

  Which one of the following protection schemes can protect branch fibers?

  A. GPON Type B single-homing protection
  B. GPON Type B dual-homing protection
  C. GPON Type A protection
  D. GPON Type C protection
  D. GPON Type C protection

• Question 135:

  In a GPON system, which of the following statements about T-CONTs are correct? (Select All that Apply)

  A. All GEM ports must be mapped to T-CONTs.
  B. All ONUs/ONTs connected to the same PON port can use T-CONTs with the same Alloc-ID.
  C. The OLT transmits services upstream in dynamic bandwidth assignment (DBA) scheduling mode.
  D. Carrier that carries services in the GPON upstream direction.
  A. All GEM ports must be mapped to T-CONTs.
  C. The OLT transmits services upstream in dynamic bandwidth assignment (DBA) scheduling mode.

• Question 136:

  (Single) The UA5000 narrowband main control board PVM and the broadband main control board IPM are connected to each other to provide voice services and broadband services. The voice service is transmitted to the IPM board through the internal IP channel, and then transmitted to the upper layer by the uplink interface of the IPM board. Network, which command should be used to configure the system networking mode?

  A. uplink tps on
  B. uplink tps off
  C. working mode integrated
  D. working mode alone
  C. working mode integrated

• Question 137:

  (single) In the EPON network, which parameter is used to filter the downlink data on the ONU?

  A. GEM-PORT ID
  B. ALLOC ID
  C. ONT ID
  D. LLID
  D. LLID

• Question 138:

  (single) Which of the following is incorrect about PPPoE description?

  A. PADT can be sent by PC or BRAS at any time during the discovery phase, terminating PPPoE conversation.
  B. The destination address of B.PADI is broadcast address 0xffffffff, and the source address is the Ethernet address of the host.
  C. The entire discovery phase of C.PPPoE includes PADI, PADO, PADR, PADS, PADT.
  D. SESSION-ID identifies the value of a PPPOE session.
  A. PADT can be sent by PC or BRAS at any time during the discovery phase, terminating PPPoE conversation.

• Question 139:

  (single) Which of the following products does not belong to the MDU?

  A. MA5616
  B. MA5612
  C. MA5620G
  D. MA5600T
  D. MA5600T

• Question 140:

  In a GPON network, DBA has the following functions:

  A. Increases the upstream bandwidth of a PON port.
  B. Improves the downstream bandwidth utilization of a PON port.
  C. Improves the upstream bandwidth utilization of a PON port.
  D. Adds more ONUs to a PON port.
  C. Improves the upstream bandwidth utilization of a PON port.