H12-321 Exam Details

  • Exam Code
    :H12-321
  • Exam Name
    :HCIP-WLAN-CEWA V1.0
  • Certification
    :Huawei Certifications
  • Vendor
    :Huawei
  • Total Questions
    :536 Q&As
  • Last Updated
    :Jan 17, 2024

Huawei H12-321 Online Questions & Answers

  • Question 431:

    Which command can display Mesh roles?

    A. display wlan mesh route
    B. display ap-system-profile
    C. display mesh-profile
    D. display mesh vap

  • Question 432:

    After HSB is configured, the HSB channel cannot be established and information on the active device fails to be backed up to the standby device. What are the possible causes for the fault? (Multiple Choice)

    A. The same priority value is configured for the two ACs.
    B. The source IP address and port number of the active AC are different from the destination IP address and port number of the standby AC.
    C. The retransmission count and interval of HSB service packets are different on the two devices.
    D. The TCP channel is not established for sending HSB service packets.

  • Question 433:

    Which of the following statements about the revertive switchover function are TRUE in the N+1 backup scenario? (Multiple Choice)

    A. By default, global revertive switchover is enabled on the standby AC.
    B. By default, global revertive switchover is disabled on the standby AC.
    C. In the N+1 backup scenario, revertive switchover cannot be disabled on the standby AC.
    D. In the N+1 backup scenario, revertive switchover can be disabled on the standby AC.

  • Question 434:

    To remain the existing wired network architecture, an enterprise deploys the AC in bypass mode. Considering the large data traffic on the WLAN and needs for AC capacity expansion in the future, it is recommended that the tunnel forwarding mode be used to transmit WLAN services.

    A. TRUE
    B. FALSE

  • Question 435:

    Regarding the MAP in the Mesh network, what is wrong with the following description?

    A. MAP is a special form of MP
    B. MAP is a special form of MPP
    C. MAP is usually used to connect terminals
    D. Any Mesh Point that supports AP functions can provide access functions for STAs.

  • Question 436:

    Which statement about wired interface parameters is TRUE?

    A. User isolation aims at centralized charging, but cannot improve communication security.
    B. By default, an AP's wired interface allows all VLANs.
    C. APs" wired interfaces can be added to VLANs only in untagged mode.
    D. APs' wired interfaces can be added to VLANs in tagged and untagged modes.

  • Question 437:

    Which statement about wired interface profile reference is TRUE?

    A. [AC-wlan-view]ap-group name mesh-mpp [AC-wlan-ap-group-mesh-mpp] mesh-profile mesh-net radio 1
    B. [AC-wlan-view] ap-group name mesh-mpp [AC-wlan-ap-group-mesh-mpp] regulatory-domain-profile domainl
    C. [AC-wlan-view]ap-group name mesh-mpp [AC-wlan-ap-group-mesh-mpp]wired-port-profile wired-port gigabitethernet 0
    D. [AC-wlan-view]ap-group name mesh-mpp [AC-wlan-ap-group-mesh-mpp]ap-system-profile mesh-sys

  • Question 438:

    On a WLAN that uses the AC6005 as the RADIUS client, which of the following statements is TRUE about the authentication-free rule profile?

    A. The authentication-free rule profile is used to permit the IP addresses of anti-virus devices such as the anti-virus gateway and firewall.
    B. The authentication-free rule profile is used to permit the IP addresses of the DNS, DHCP, and authentication servers.
    C. The authentication-free rule profile can use advanced ACLs.
    D. The authentication-free rule profile can permit specified IP addresses only by using ACLs.

  • Question 439:

    What is the correct description about the second Fresnel zone below?

    A. If the RF signal is at the same frequency, out of phase, and the intersection of the main signal, the out-of-phase signal will weaken or even cancel the main signal. Since the reflection is one of the factors that cause the out-of-phase signal to interfere with the main signal, the point-to-point communication chain is evaluated. When considering the road, the influence of the second Fresnel zone on the signal must be considered.
    B. If the signal of the second Fresnel zone is reflected to the receiving end due to antenna height and terrain, the link quality may be reduced.
    C. The impact of the second Fresnel zone should still be taken into account when planning the network or troubleshooting, especially in flat, arid environments such as deserts.
    D. The first Fresnel zone surrounds the second Fresnel zone.

  • Question 440:

    Which of the following techniques are part of the way to implement STA fast roaming?

    A. PMK caching
    B. Key negotiation down
    C. Improve terminal roaming initiative
    D. Home agent is deployed on the AC

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Huawei exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your H12-321 exam preparations and Huawei certification application, do not hesitate to visit our Vcedump.com to find your solutions here.