Extreme Networks EW0-300 Online Practice Questions and Exam Preparation

Extreme Networks EW0-300 Online Questions & Answers

• Question 71:

  DVMRP uses the same IP packet header as IGMP to exchange routing datagram.

  A. True
  B. False
  A. True

• Question 72:

  When you create an ACL entry on Summit 48i switch it works in the following way

  A. inbound
  B. outbound
  C. bi-directional
  D. The ACL entry needs to be enabled first to work.
  A. inbound

• Question 73:

  Given router interfaces 10.0.0 1.24, 10.10.10.10/24, 192.168.0.1/24 and 192.168.255.254/24 on a Summit 7i switch. What will be the OSPF router ID upon switch reboot, given the following CLI command config ospf routerid automatic?

  Pending

• Question 74:

  What does the QoS Monitor show by default when using the command show port 1 qosmonitor?

  A. Ingress traffic
  B. Egress traffic
  C. Both
  D. None of the above
  B. Egress traffic

• Question 75:

  In a Summit 5i switch, a QoS policy is applied on a basis.

  A. per port
  B. per queue, per port
  C. per queue
  D. None of these
  B. per queue, per port

• Question 76:

  IP Multicast uses TCP socket number 1812 for packet exchange

  A. True
  B. False
  B. False

• Question 77:

  What is the RP-set?

  A. It is the information of which RP are available for what Multicast groups.It is send by the BSR towards all PIM routers
  B. It is the information of which multicast groups are activeIt is send by the RP towards all PIM routers
  C. It is the information of which BSR are available for what Multicast groups.It is send by RP towards all PIM routers
  D. It is the information, stored by all RP, needed to find the BSR,
  A. It is the information of which RP are available for what Multicast groups.It is send by the BSR towards all PIM routers

• Question 78:

  In SLB the forwarding mode is the method a switch uses to forward traffic to the virtual servers. On the Summit 7i switch four forwarding modes are supported, select the two forwarding modes that are hardware based.

  A. Transparent mode
  B. Translation mode
  C. Port Translation mode
  D. GoGo mode
  A. Transparent mode
  B. Translation mode
  C. Port Translation mode
  D. GoGo mode

• Question 79:

  The Alpine 3802 switch contains a 3-slot chasis that can be populated with up to three I/O modules.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 80:

  It is possible to set an STP-threshold to switch from a shared tree to a shortest path tree. This switch over will be initiated by

  A. The Rendezvous Point
  B. The Bootstrap Router
  C. A last hop router
  D. The router nearest to the source
  C. A last hop router